Yeoman YM-CL8HB manual Hearth Fixing, Cast TOP, Fixing holes Hearth mounts, Top Flue Rear Flue

Page 26

INSTALLATION INSTRUCTIONS

5.HEARTH FIXING

5.1If the appliance is to be fixed to the hearth then use the hearth mount locking tabs shown in Diagram 12.

—Position the appliance where required on the hearth and mark the location of the two fixing holes in the hearth mounts.

—Drill the required sized holes into the hearth. —Use suitable fasteners to fix in place.

12

Fixing holes in

 

hearth mounts

PR8755

 

6. CAST TOP

This appliance can be fitted with an optional cast top plate. The type of plate will depend on whether the appliance is installed with a top* or rear flue exit.

 

Top Flue

Rear Flue

 

 

 

Yeoman CL8

YM-CL8CT

YM-CL8CTR

*The cast top must be fitted at the same time as the flue connection (see Installation Instructions, Sections 1 & 6).

6.1The cast top plate has 4 cast feet on the bottom to space it off the top of the appliance by 6mm and allow the door to open freely.

13

Cast feet

 

PR8756

6.2Place the cast top plate feet down on top of the appliance.

—Ensure the cast top is flush with the front and sides of the appliance.

—For the top flue version, position the cutout over the flue ring.

14

Line up edges of cast top plate with the appliance

PR8744

26

Image 26
Contents Yeoman CL YM-CL8HBContents Retailer appliance was purchased from Appliance Commissioning ChecklistInstallation Engineer Essential Information Must be completedSerial Number User InstructionsGeneral Points ThermostatUse a protected gloved hand to operate Heating System controlsDo not place tool on hot surfaces e.g. top of stove Normal Running Using the Appliance for the First TimeCondensation Seasonal USELighting the Appliance Solid fuelDo not load above the log guard or base of baffle Running The applianceBurning wood Burning tips RefuellingThermostat Operation ASH Removal OVER-FIRING Wood burning trayExtended burning Over-firing can cause permanent damage to the applianceChimney fire General CleaningCleaning Glass Chimney SweepingTroubleshooting tips Care of stove Seasonal useAll or some of the radiators do not get hot Open up the airwash to makeBoiler Output Chart TECHNICAL SPECIFICATIONStandard Features YeomanCast Top Plate Incl. feet @ 6mm on underside Yeoman DimensionsAll dimensions are in mm 25.4mm = 563 572 363 105 478 153/6 449 441 225 430 224 317Max. Draught = 2.0mm Wg Min. Draught = 1.0mm Wg U.K Site RequirementsFlue or Chimney Flue PlateHearth Dimensions Flue Outlet Positions80mm Walls Next to a HearthRequirement for the walls Without Liner System 150 PRE-INSTALLATION ChecksFlue Flue / Chimney SizeMm² 4400 Additional Ventilation VentilationModel Changes to Document J, England & Wales, from 01/10/2010Top flue pipe installation Installation InstructionsInstalling the Appliance Legal requirementsDo not use a 90˚elbow to make this connection Secure with self tapping screw Seal the connecting jointsRear flue pipe installation To chimney connection as detailed in building regulationsEnsure baffle sits On front supports Baffle In Place Fitting and Removal of the BaffleRemoval of Riddling Mechanism Do not modify the baffleUnscrew the boss Remove Rear Bar see DiagramLift bars to remove Replace in reverse orderFixing holes Hearth mounts Hearth FixingCast TOP Top Flue Rear FlueCentral Heating System Electrical Supply Pipe work DiagramsPump Conventional Pipe work systemsFeed Expansion Cistern Link UP Systems Controls GeneralInstructions for Use CommissioningCommissioning Give the copy of the Instructions to the customerAnnual Service Fitting a NEW Door Glass Removal of the LOG GuardFitting and Removal of Baffle Do not use appliance without the log guard in positionMid door Rope seal E Joint Fitting a new door sealDo not over tighten the clamp as this could break the glass Hetas Approved Chimney Sweeps Adjusting Door Catch & HingesTo adjust the door hinge plate assembly Spare Parts List Cast Door Service Records