EMULEX MODEL 375 SAN STORAGE SWITCH | CHAPTER 2: SWITCH INSTALLATION |
USER’S GUIDE |
Installing the Retention Clips (optional)
The switch ships with two, optional retention clips to secure the power cords in each power supply/fan module’s power receptacle. Screws (4) and washers (4) are provided for the clips.
To install the retention clip:
1.Secure the retention clip to the switch by aligning the retention clip with the two screw holes located to the left and the right of the module’s power receptacle. The retention clip mounting loops should be facing downward.
2.Place the washer on the screw prior to inserting the screw through the retention clip’s mounting loop.
3.Using a screwdriver, tighten the screws to secure the retention clip to the power supply/fan module.
To insert the power cord with the retention clip in place:
1.Insert the power cord plug into the module’s power receptacle. The plug must initially be inserted into the receptacle at an angle to avoid the retention clip.
2.Once the power cord plug is firmly inserted in the module’s power receptacle, the retention clip fastens over the end of the power cord plug to secure it in the power receptacle.
To remove the power cord with the retention clip in place:
Press down on the retention clip while removing the power cord from the module’s power receptacle.
EMULEX CORPORATION | 8 |
PART NUMBER
