IMPORTANT SAFETY INFORMATION
!WARNING! Not Following these instructions may cause severe injury or death.
Audible Alarm Reset Switch Installation
Manual Reset for the Audible Alarm
•UL325 standard requires an audible alarm to go off after two consecutive events detected by the primary entrapment protection of the gate operator (obstruction sensor).
•The audible alarm will continue to sound for 5 minutes or until a stop command gets actuated.
•The Stop command can be actuated in two different forms:
1.Using the Built in Stop switch on the Control Board or;
2.Using an External Stop button within the sight of the gate, away from moving parts of the gate and out of reach of children.
a.Controls intended for user activation must be located at least six feet (6’) away from any moving part of the gate and where the user is prevented from reaching over, under, around or through the gate to operate the controls. Outdoor or easily accessible controls shall have a security feature to prevent unauthorized use.
b.The Stop and/or Reset button must be located in the
2
Warning Placard Installation
•All Warning Placards must be installed where visible in the area of the gate.
•A minimum of two placards shall be in- stalled.
•A placard is to be installed in the area of each side of the gate and be visible.
1 2 | VIKING TECHNICAL SUPPORT 1.800.908.0884 |
|
|