Viking Access Systems Q7 manual Anti-Tailgate, Open Commands & Guard Station, ATG Anti-Tailgate

Page 33

ACCESSORY CONNECTIONS

Anti-Tailgate, Open Commands & Guard Station

!TECHNICAL TIP: For more information regarding accessory connections and terminal functions, refer to “Appendix (A)” on pages 42-43.

Open Commands

“Exit”, “Fire” and “Strike” input terminals all provide an open command to the control board. Any device connected as shown will open the gate.

+

-

+

 

 

 

 

N.O.

COM

+

-

-

 

 

 

 

 

 

 

N.O.

 

 

 

 

 

COM

N.O.

 

 

 

 

 

 

 

 

COM

 

Guard Station

!All three buttons must be a Normally Open “N.O.” type of switch, and can share the same common “C” connection to “GND”.

“ATG” Anti-Tailgate

This input will stop the gate when the vehicle triggers the sensor, then closes the gate when the vehicle leaves the sensor; preventing unauthorized vehicles from entry.

+ -

COM

N.O.

VIKING TECHNICAL SUPPORT 1.800.908.0884

3 1

 

 

Image 33
Contents Instructions Viking Q-7 Slide Gate Operator Vehicular Gate Operator Revision Q7NXMN10.E December Description Parts DiagramOperator References Control Board References EMI Board ConnectorTable of Contents Important Safety Information Important Safety InstructionsImportant Installation Instructions Important Installation Instructions General Safety Precautions MaintenanceGlossary UL325 Gate Operator ClassificationsSecondary Entrapment Protection Photo Beam non-contact sensor InstallationWhen manual operation is required Edge Sensor contact sensor InstallationManual Release To resume normal operationManual Reset for the Audible Alarm Audible Alarm Reset Switch InstallationSpecifications Single Phase 50Hz / 60HzLocate Control Buttons Concrete Pad Installation Gate Operator InstallationSuggested Positive Stop Types Positive Stop InstallationOperator Positioning Step Technical TIP Before completing the installation procedureElectrical Installation Tips for proper ground installationHigh Voltage Supply Option Solar Supply Option Electrical InstallationLimits Setup To Readjust the Open Limit To Readjust the Close LimitTwo Wire Communication MASTER/SLAVE SetupCable Requirements MS1 MS2Required ADD-ON Wireless Communication OptionsInitial Settings Control Board SetupTimer Hold Open Timer ODSLast Open Power Failure Option Auto Open Power Failure OptionODS Obstruction Detection Sensor Obstruction Sensor Primary Entrapment ProtectionViking Heater Viking Lock ModeThis page Left Blank Intentionally Re-Open Photo Beam vehicular Safety Accessory ConnectionsCOM + Check for proper operationRadio Receiver Typical Open-Stop-CloseOpen Only Open Commands Anti-Tailgate, Open Commands & Guard StationGuard Station ATG Anti-TailgateViking Loop Rack Guidelines for Loop Installation Accessory ConnectionsPower for the Locks Magnetic Lock, Lock SolenoidMagnetic Lock Lock Solenoid Barrier Arm B-12 Synchronization Option Synchronization with B-12LED References TroubleshootingTroubleshooting LCD Display References LCD MSG MeaningTroubleshooting Error Messages Check SolutionsPower Connections Access Control ConnectionsRelays In General Appendix aGeneral Technical TIP Viking usesCommon Radio Receivers Connections Solar Applications Appendix CPanels Batteries & FuseViking Konnect Diagnostic Tool On-site remote Viking Expansion ProductsViking Konnect Master/Slave Kit Secure and reliable OUR Continuous Commitment to Excellence Standard Features