Viking Access Systems Q7 Control Board Setup, Initial Settings, Ods, Obstruction Detection Sensor

Page 26

CONTROL BOARD SETUP

Initial Settings

“Speed” Motor Speed

Increases or decreases the speed of gate travel.

“Overlap” Overlap Delay

Delays the gate from opening for the selected amount of time from 1-6 seconds.

!Typically not used on slide gates. For Master/Slave application, the control board that has this feature turned on is the master and will close first.

“ODS”

Obstruction Detection Sensor

Sets the amount of force required to trip the inherent obstruction sensor.

See page 26 for more details about this feature.

“Timer”

Hold Open Timer

Automatically closes the gate after the selected amount of time from 1-60 seconds.

Turning the dial between “0” and “OFF” will disable this feature, requiring a close command to close the gate.

2 4	VIKING TECHNICAL SUPPORT 1.800.908.0884

Image 26

Contents Instructions Viking Q-7 Slide Gate Operator Vehicular Gate Operator Revision Q7NXMN10.E December Parts Diagram DescriptionOperator References EMI Board Connector Control Board ReferencesTable of Contents Important Installation Instructions Important Safety InformationImportant Safety Instructions Important Installation Instructions Maintenance General Safety PrecautionsUL325 Gate Operator Classifications GlossaryPhoto Beam non-contact sensor Installation Secondary Entrapment ProtectionManual Release Edge Sensor contact sensor InstallationWhen manual operation is required To resume normal operationAudible Alarm Reset Switch Installation Manual Reset for the Audible AlarmLocate Control Buttons SpecificationsSingle Phase 50Hz / 60Hz Gate Operator Installation Concrete Pad InstallationPositive Stop Installation Suggested Positive Stop TypesOperator Positioning Technical TIP Before completing the installation procedure StepHigh Voltage Supply Option Electrical InstallationTips for proper ground installation Electrical Installation Solar Supply OptionLimits Setup To Readjust the Close Limit To Readjust the Open LimitCable Requirements MASTER/SLAVE SetupTwo Wire Communication MS1 MS2Wireless Communication Options Required ADD-ONTimer Hold Open Timer Control Board SetupInitial Settings ODSAuto Open Power Failure Option Last Open Power Failure OptionObstruction Sensor Primary Entrapment Protection ODS Obstruction Detection SensorViking Lock Mode Viking HeaterThis page Left Blank Intentionally COM + Accessory ConnectionsRe-Open Photo Beam vehicular Safety Check for proper operationOpen Only Radio Receiver TypicalOpen-Stop-Close Guard Station Anti-Tailgate, Open Commands & Guard StationOpen Commands ATG Anti-TailgateViking Loop Rack Accessory Connections Guidelines for Loop InstallationMagnetic Lock Lock Solenoid Power for the LocksMagnetic Lock, Lock Solenoid Synchronization with B-12 Barrier Arm B-12 Synchronization OptionTroubleshooting LED ReferencesTroubleshooting LCD MSG Meaning LCD Display ReferencesTroubleshooting Error Messages Solutions CheckAccess Control Connections Power ConnectionsGeneral Appendix aRelays In General Technical TIP Viking usesCommon Radio Receivers Connections Panels Appendix CSolar Applications Batteries & FuseViking Konnect Master/Slave Kit Secure and reliable Viking Konnect Diagnostic Tool On-site remoteViking Expansion Products OUR Continuous Commitment to Excellence Standard Features