CDA 4Q4 manual Ignitor S Flame failure probe T

Page 17

MODELS WITH TRIPLE RING BURNER -

CORRECT POSITIONING OF THE TRIPLE RING BURNER

The triple ring burner must be correctly

Figure 16

positioned (see fig. 14); the burner ribs

 

must be fitted in their housing as

 

shown by the arrow.

 

The burner correctly positioned must not rotate (fig. 15).

Then position the cap “A” and the ring “B” (figs. 15 - 16). They shall be level.

The pan support shall be correctly

positioned as indicated in fig. 17. The pan support shall be level and must not rotate.

Be sure not to fit the auxiliary, semi- rapid or rapid burner pan support on the triple-ring burner. The auxiliary, semirapid or rapid burner pan sup- port IS ONLY to be used on the auxil- iary, semirapid or rapid burners.

Figure 14

Figure 17

Ignitor "S"

Flame failure probe "T"

Figure 15

A B

17

Image 17
Contents 4Q4 Four Burner Gas Hob Declaration of CE conformity Contents Before Using for the First Time Important Safeguards & Recommendations Features Control Panel Cooking PointsGAS Burners Use of the HobLighting the Burners Max 36 cm Choice of BurnerCorrect USE of TRIPLE-RING Burner Page Glass Surface Cleaning and MaintenanceGeneral Tips Control Knobs Enamelled PartsGAS Taps Important Warning Burners and GridsIt is very important to check that Ignitor S Flame failure probe T Tips For Installation Location Technical Information for the Installer 585 Fastening the Cooktop Ventilation requirements Gas supply requirements Installation & Service Regulations United KingdomGas Connection Installation to Natural GASConnection to the GAS Supply GAS ConnectorReplacing the Burner Injectors Conversion to Natural Gas or LPGCat II 2H3+ Table for the choice of the InjectorsLubrication of the gas taps Minimum Burner Setting AdjustmentElectrical Connection Section of the Supply Cable Type H05V2V2-F Appliance servicing Limit of Cover GuaranteePage Page Gas on glass cooktops