CDA 4Q4 manual Location

Page 19

Location

The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but not in a room or space containing a bath or a shower.

The appliance must not be installed in a bed-sitting room of less than 20 m3.

The appliance is designed and approved for domestic use only and should not be installed in a commercial, semi commercial or communal environment.

Your product will not be guaranteed if installed in any of the above environments and could affect any third party or public liability insurances you may have.

This hob should only be installed by a qualified installer. Failure to observe this rule leads to cancellation of the guarantee.

The appliance must be installed correctly, in compliance with the regulations in force and following the manufacturer's instructions.

Any repair or maintenance must be performed with the appliance switched off.

These hobs are designed to be fitted into 600 mm deep kitchen units.

These appliances have been designed and manufactured to be fitted into heat-resis- tant units.

The walls of the units must be capable of resisting temperatures of 75 °C above room temperature.

We would point out that the adhesive which bonds the plastic laminate to the furni- ture must withstand temperatures not less than 150 °C to avoid elamination.

Avoid installation near inflammable materials (e.g. curtains).

19

Image 19
Contents 4Q4 Four Burner Gas Hob Declaration of CE conformity Contents Before Using for the First Time Important Safeguards & Recommendations Features Control Panel Cooking PointsGAS Burners Use of the HobLighting the Burners Max 36 cm Choice of BurnerCorrect USE of TRIPLE-RING Burner Page General Tips Cleaning and MaintenanceGlass Surface GAS Taps Enamelled PartsControl Knobs Important Warning Burners and GridsIt is very important to check that Ignitor S Flame failure probe T Tips For Installation Location Technical Information for the Installer 585 Fastening the Cooktop Ventilation requirements Gas supply requirements Installation & Service Regulations United KingdomGas Connection Installation to Natural GASConnection to the GAS Supply GAS ConnectorReplacing the Burner Injectors Conversion to Natural Gas or LPGCat II 2H3+ Table for the choice of the InjectorsLubrication of the gas taps Minimum Burner Setting AdjustmentElectrical Connection Section of the Supply Cable Type H05V2V2-F Appliance servicing Limit of Cover GuaranteePage Page Gas on glass cooktops