Bosch Appliances FMR-1000-RCMD 4Mounting, Removing the Cover Frame, Surface Mounting

Remote Command Center Mounting en 7

FPA-1000 FMR-1000-RCMD FMR-1000-RA

Figure 3.1 System Overview

4Mounting

The Remote Command Center should be mounted no higher than shoulder height of the shortest person operating the system.

4.1 Removing the Cover Frame

The device comes with the mounting material and language tabs in separate bags. For removing the device’s cover frame from the annunciator unit, hold the assembly and unlock the snap-fit hooks on one side. Pull the cover frame off.

		Figure 4.1 Removing the Cover Frame (before Installation)
4.2	Surface Mounting
	1.	The back box provides three knockouts for 1/2 in. diameter conduit connectors in the
		back, bottom and top side (refer to Figure 4.2, Item 1). To get a clean break, remove the
		knockout from the inside of the box.
	NOTICE!
	To get a clean break, remove the knockout from the inside of the box.
	2.	Install the back box with the arrow pointing up (refer to Figure 4.2, Item 2).
	3.	Use the back box as a template to mark the location of the mounting holes (refer to
		Figure 4.2, Item 3). Provide an opening in the mounting surface for the wiring. Pre-start
		the screws. Do not secure the screws at this point.
	4.	The built-in bubble level allows you to level horizontally without extra tools when
		securing the base (refer to Figure 4.2, Item 4).

Bosch Security Systems, Inc. Installation and Operation Guide F.01U.078.098 3.0 2011.11