Hearth and Home Technologies SOHO-CE manual Operating Instructions, Before Lighting Appliance

Page 28

13 Operating Instructions

A. Before Lighting Appliance

Before operating this appliance have a qualified tech- nician:

•Remove all shipping materials from inside and/or underneath the firebox.

•Review proper placement of logs and mineral wool.

•Check the wiring.

•Check the air shutter adjustment.

•Ensure that there are no gas leaks.

•Ensure that the glass is sealed and in the proper position.

•Ensure that the flow of combustion and ventilation air is not obstructed (flue terminations).

WARNING

Glass door must be in place when appliance is operating.

Risk of:

•Combustion Fumes

•Fire

Do NOT operate appliance with glass door removed.

•Open viewing glass for servicing only.

•Glass door MUST be in place and sealed before operating appliance.

•Only use glass door certified for use with appliance.

•Glass replacement should be done by qualified technician.

WARNING

HOT! DO NOT TOUCH.

SEVERE BURNS MAY RESULT.

CLOTHING IGNITION MAY RESULT.

Glass and other surfaces are hot during operation and cool down.

•Keep children away.

•CAREFULLY SUPERVISE children in same room as appliance.

•Alert children and adults to hazards of high temperatures.

•Do NOT operate with protective barriers open or removed.

•Keep clothing, furniture, draperies and other combustibles away.

This appliance is not supplied with an integral barrier to prevent direct contact with the fixed glass panel. Do NOT operate the appliance without a protective barrier installed.

Contact your dealer or Hearth & Home Technologies if help is needed to properly install one.

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualified installer, service agency or the gas supplier.

WARNING

Do NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

28

Heat & Glo • Soho-CE • 2111-900 Rev. D • 6/07

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Model Soho-CE What to do if you smell gasCongratulations Homeowner Reference InformationTable of Contents Listing and Code Approvals Appliance CertificationNon-Combustible Materials Specification Combustible Materials SpecificationDesign and Installation Considerations Getting StartedInspect Appliance and Components Tools and Supplies NeededSelecting Appliance Location Framing and Clearances84.1 74.0 118.7 89.2 Constructing the Appliance Chase ClearancesTermination Locations Flue Termination Minimum ClearancesSee .4 for specific clearances Cm minimum in snow regionsAlcove Applications Flue Information and Diagrams Flue Table KeyUse of Elbows Measuring StandardsFlue Diagrams Horizontal Termination One Elbow Two Elbows One Elbow Minimum Maximum+ H Maximum = 11.9 m Maximum = 4.6 m Two Elbows Minimum + H 2 Maximum Elbow only Not AllowedThree Elbows Minimum Maximum Horizontal Termination Three Elbows+ V 2 + H = Maximum = 11.9 m + H 2 Maximum = 4.6 m Vertical Termination No Elbow Two Elbows V1 = 11.8 m MaximumTwo Elbows V1 Minimum Maximum V1 + V2 + H Maximum = 11.9 mThree Elbows V1 Minimum H1 + H2 Maximum Vertical Termination Three Elbows+ V2 + H1 + H2 Maximum = 11.9 m Maximum = 4.3 m Flue Clearances and Framing Pipe Clearances to CombustiblesWall Penetration Framing Combustible Wall PenetrationInstalling Attic Shield Installing the Ceiling FirestopVertical Penetration Framing Appliance Preparation Securing and Leveling the ApplianceInstalling Flue Pipe Assembly of Flue SectionsInstall Support Brackets Attach the First Flue Component to Starting CollarsInstalling the Horizontal Termination Cap Installing Firestops and Horizontal Termination CapFor Horizontal Runs Wall shield firestops are Required Install Roof Flashing and Vertical Termination Cap Assembling and Installing Storm Collar Sharp EdgesGas Information Gas Pressure RequirementsGas Connection Natural Gas Propane Butane G20 G31 G30 G25Electronic Ignition System Wiring Electrical InformationFinishing Facing MaterialMantel Projections See for combustible/non-combustible definitionsAppliance Setup Clean the ApplianceAccessories Ember PlacementLog Assembly LOGS-SOHOCE Positioning the LogsRemoving Glass Assembly Glass AssemblyReplacing Glass Assembly Operating Instructions Before Lighting ApplianceLighting the Fireplace Electronic IgnitionInitial Break-in Procedure Frequently Asked QuestionsAfter Appliance is Lit Troubleshooting Symptom Possible Causes Corrective ActionsElectronic Ignition System No transmission, motor Receiver mustMaintenance Tasks Maintaining and Servicing ApplianceInspect Maintenance Tasks Recommend addition of screen if one is not presentVerify no obstructions to airflow through the louvers Operating properly. Replace as necessaryAppliance Dimension Diagram Appliance Dimensions TableReference Materials Location CentimeterLog Set Assembly Service Parts List108 SOHO-CE Service Parts SOHO-CELimited Lifetime Warranty Limited Lifetime Warranty Heat & GLO GAS Appliance ProductsContact Information Important operating

SOHO-CE specifications

Hearth and Home Technologies (HHT) has long been a leader in the design and manufacturing of innovative hearth products, and their SOHO-CE model is no exception. This sleek and modern electric fireplace represents a perfect synthesis of aesthetic appeal and functional engineering, specifically tailored for small office/home office (SOHO) settings.

One of the standout features of the SOHO-CE is its Clean Edge design, which allows for a seamless installation that blends effortlessly into any room. This contemporary electric fireplace has a minimalist frame available in various finishes, making it versatile enough to complement different interior styles, from modern to rustic. Its elegant look is well-suited for both residential and commercial spaces, providing an inviting ambiance that enhances the room's overall atmosphere.

The SOHO-CE employs state-of-the-art LED technology to create realistic flame effects. These flames can be adjusted to suit individual preferences, giving users control over the intensity and color. This customization is essential in creating the ideal mood for any occasion, whether it’s a productive workday or a cozy evening at home. In addition, the electric fireplace boasts a safe and efficient heat source with adjustable heat settings, ensuring comfort without compromising safety.

Smart technology integration is another significant characteristic of the SOHO-CE. It can be controlled via a user-friendly app, allowing for remote operation right from a smartphone or tablet. This feature is particularly beneficial for those who want to set the fireplace to a specific schedule, ensuring their space is warm and inviting upon arrival.

In terms of energy efficiency, the SOHO-CE stands out with its eco-friendly operation. As an electric fireplace, it eliminates the need for venting and reduces the emission of pollutants, making it a responsible choice for the environment. It also offers the convenience of heating only when necessary, reducing energy consumption.

Durability is built into the SOHO-CE’s design, featuring high-quality materials that ensure longevity and performance. This electric fireplace is also easy to maintain, with no need for chimneys or flue cleaning. Overall, Hearth and Home Technologies' SOHO-CE is a remarkable addition to any SOHO setting, marrying functionality with style for an exceptional user experience. Whether for work or leisure, this electric fireplace elevates any space.
Top Page Image Contents