R
PANEL SET and CAST TRIM SET
STANDARD SIZE: | LARGE SIZE: 34”h x 48”w |
Panel and Cast Trim must be ordered separately.
Included in Panel Kit: (2) side panels, left and right; (1) panel top; (2) trim pieces; (1) trim top; (1) fastener package.
Included in Cast Trim Kit: (2) cast trim legs, left and right; (1) cast trim header; (2) cast trim footers, left and right.
Tools Needed: Powered Phillips Head Screw Driver
1.Remove contents from box being careful not to scratch or damage cast trim pieces.
2.Lay the panel set face down on protective covering to prevent scratching the painted surface.
3.Secure panel set together with screws provided. Figure 14A
4.Now bend the tabs down toward the backside of the panel set, on top piece and on each leg. Leave panel set face down.
5.Place the corresponding cast trim pieces (2 cast trim legs and 1 cast trim header) underneath panel set, also face down.
6.Place washer provided over tab and secure the trim and panel together with screw. Continue for all tabs.
7.Secure cast footers with screws.
NOTE: DO NOT PICK UP ASSEMBLED UNIT BY CORNERS. IT IS TOO HEAVY AND MAY DAMAGE THE PANELS. PICK UP FROM CENTER.
8.Slide assembled panel and trim over top of the insert into place.
9.Secure panels to insert with
Figure 13B.
2. Bend tabs
1. Screw side panels
to top panel
2. Bend tabs
Tab with screw hole to secure panel to insert
. Install Cast Trim Header
Figure 14A
Secure side panels to insert with screws
Figure 14B
COMPLETED VIEW
PANEL and GOLD TRIM SET
BASIC STANDARD SIZE: 30”h x 40”w
1.Repeat Steps 1 - 3 above.
2.To assemble the trim, attach the 2 side trim pieces to the top trim at each corner using the “L” bracket
included in fasteners package. Figure 14C
3. Slide panel and trim over top of the insert and into position.
View of "L" Bracket
installed
Tab with screw hole to secure panel to insert
Figure 14C | Figure 14D |
|
|
Page 14 | September 1, 2008 |