Sears N9MP2050B12B1 All ModelsVentthru RightSide, All Models Vent thru Right Side See Figure

All ModelsVentthru RightSide

	4}
Yellow or black Plastic Cap
	On Some Models
	ONLY
	2" PVC Coupling
oJ	Either: The PVC
Vent Drain	Drain Tee or a field
& Clamps	supplied2" PVC Tee
	Single Pressure Switch Detain

Dual Pressure Switch

&Clamps

SIDE VIEW

_otatedownward

NOTE.Built'f-inchannelwill heangled 5° to10° also.

Tee Trap White PVC

ElbowsTubes (2) & Clamps Black, 1/z" ID (loose parts bag)

Barbed Coupling, 112"OD

parts bag)

Drain Line Vent Tee 3/4"PVC CPVC(Field supplied)

314"PVC X 1/2" CPVC

(Loose parts bag)

Casing Grommet

"Black Rubber sis" CPVC

(Loose parts bag) 25-24-44

All Models Vent thru Right Side (See Figure 11)

Disconnect the black Drain Tube between the drain vent and the Trap.

Rotate the inducer 180 ° for a right side vent after loosening the 4

inducer attachment screws. Reinstall and retighten the inducer screws to 20" pounds torque.

Using the 1/2" OD barbed coupling in the loose parts bag connect

together with the 2 short 1/2' , ID elbowtubes and connect the lower discharge port of the vent drain to the Trap. Secure all connections with clamps.

Install the vent pipe grommet into the casing

Cut an appropriate length of 2" PVC pipe long enough to exit the cabinet and connect the vent drain to either:

Install casing grommet (black rubber 5/8" ID grommet - in loose parts bag)

Install the 1/2" CPVC street elbow on discharge of Trap

Install the black PVC tube connector (3/4" PVC x 1/2" CPVC from loose parts bag) as shown in the illustration above

Cut the black Drain Tube (5/8" ID - in loose parts bag) to length to fit between Trap and tube connector through grommet.

Clamp both ends of the Drain Tube using clamps provided.

Glue the CPVC street elbow to the Trap using appropriate cleaner and solvent cement.

•A standard field supplied 2" PVC tee (N9MP1 and 2 mod- els), or

•A 2" PVC coupling fastened onto the Drain Tee (*9MPD models)

Install Tee Trap into bottom section of Tee.

Remove plug from the side of the furnace casing where Drain Tu be will exit.

Connect the Tee trap and the main drain line exiting the casing as shown in Figure 18.

Note: It is recommended that all PVC piping and fitting connec- tions be fit up and inspected before final cementing. Both the in-

ternal Trap and the external Tee Trap must be primed before

operation. Verify all condensate drain connections are securely clamped. A coupling and clamps (in loose part bag) may be installed as shown for future servicing of the vent system.

[_ 440 01 1020 04