Goodman Mfg TSTATG2111 owner manual Selecting Your Desired Temperature adjusting the setpoints

Page 13

Air Conditioning & Heating

Selecting Your Desired Temperature (adjusting the setpoints)

AUTO OR PROGRAM MODE

Pressing the UP or DOWN buttons in Auto or Program mode will adjust both the heat and cool set temperatures

simultaneously.Adjust the desired set temperature with the

12:00

Pm

76

 

 

 

 

COOL

AUTO

70 HEAT

68

2

buttons.

HEAT OR COOL MODE

Pressing the UP or DOWN buttons in Heat or Cool mode will adjust only the heat or cool set temperature.

12:00

Pm

76

 

 

COOL

70

Adjust the desired

set temperature with the

buttons.

Using the Fan Button

12:00

Pm

76

 

 

 

 

COOL

AUTO

70 HEAT

FanOn68

Press

Fan On indicates constant fan operation. You may turn the fan on even if the thermostat is in the Off mode. Pressing the FAN button toggles this feature on or off.

Page 2.4

Image 13
Contents Owner’ ’sManual l 4Z95 How to Use This Manual Glossary of Terms Table of Contents Contents Front Panel HeatCool Display FeaturesService Filter icon Section Using the Fan Button Setting the Clock Selecting the Heat or Cool Selecting Your Desired 1200 Am Setting the ClockSelect Mode by Pressing the Mode Button Selecting the Heat or Cool ModeAuto or Program Mode Selecting Your Desired Temperature adjusting the setpointsSetting the Clock Setting the Clock Contents Programmable or Non-Programmable Thermostat Press Setup button to enter Setup screensManual or Auto-Changeover Thermostat Operating Mode when the Thermostat is Configured to be Cooling Only Time Schedule for Programmable with Auto-Changeover If the thermostat is Selecting Your Desired Temperature adjusting setpoints Viewing the Outdoor Temperature Viewing the Outdoor Temperature Schedule Programming a Daily600 Programming a Daily Schedule800 1000 Delay Using the Fan Button Setting the Fan-Off TimeUsing the Fan Button 003 Setting the Fan-Off Time DelayContents Turning On/Off the Backlight 1200 Locking/Unlocking the KeypadProgramming Run-Time Alerts How to Set and Reset the Service Filter Fan Run-Time Alert Until this setup screen appears How to Set and Reset the UV Light Run-Time AlertElectric Heat and Heat Pump Operation Viewing the Heat Pump Reversing Valve Jumper Settings Viewing the Electric Heat Jumper Setting Using Emergency Heat 11.3 Adjusting the Deadband 11.4Adjusting the Heat/Cool Differential Adjusting the Cycles Per Hour Adjusting the Deadband Adjust the deadband for the 1st stage 12.3 1200 Pm Calibrating the Temperature and Humidity SensorsAccessories Advanced Setup Index Heat Manual Time Schedule 88-746 Rev Factory Default Settings for default values see Resetting the Thermostat to