Air Conditioning & Heating
Adjusting the Heat/Cool Differential
The Heat and Cool setpoints will not be allowed to come any closer to each other than the value in this step. This minimum difference is enforced during
MODE
Press SETUP button to enter Setup screens.
Press the MODE button repeatedly until this setup screen appears.
Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE button to move back- wards through the setup screens.
11
Adjust the minimum difference between cooling & heating setpoints.
(0 - 6 )
d IF | Setup | |
13 | ||
| ||
| COOL | |
| 2 HEAT |
Press
Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.
Note: To increase the spread between the heating and cooling setpoints, press the MODE button until only the heat setpoint is displayed. Adjust the desired setpoint. Wait two seconds after adjusting the set point so the thermostat can accept the change. Press the MODE button until only the cool setpoint is displayed. Adjust the desired setpoint. Wait two seconds after adjusting the set point so the thermostat can accept the change. Press the MODE button again to enter the
Page 11.2