Goodman Mfg TSTATG2111 owner manual How to Set and Reset the Service Filter Fan Run-Time Alert

Page 37

Air Conditioning & Heating

How to Set and Reset the Service Filter (Fan Run-Time) Alert

This counter keeps track of the number of hours of fan run-time whether the fan is energized in the Heating or Cooling modes, or in stand alone fan operation. The Service Filter icon will appear after the preset number of hours of fan run-time in step #7 (below) has been achieved. Setting this counter to zero in step #7 will prevent the Service Filter icon from ever appearing.

Press SETUP button to enter Setup screens.

Note: Press the MODE button momentarily to move through the setup screens. Press and hold the MODE

9

MODE

Press the MODE button repeatedly until this setup screen appears.

button to move back- wards through the setup screens.

		Hours the fan has
		run since last reset		0	Setup
	Press			0	6
	Press			Service Filter	6
	Reset the counter to 0 to			Service Filter
	remove the Service Filter
	icon from the display.
	FAN

Press

MODE

Adjust the number of hours, in increments of 50, the fan will run before the Service Filter icon appears on the display. 0 = off.

Setup

07

Service Filter

Press

(0 - 1950 hours)

Press the PROGRAM button to leave the Setup screens. If no buttons are pressed, the display will leave the setup screens after 30 seconds.

Page 9.2

Image 37

Contents Owner’ ’sManual l 4Z95 How to Use This Manual Glossary of Terms Table of Contents Contents Front Panel HeatCool Display FeaturesService Filter icon Section Using the Fan Button Setting the Clock Selecting the Heat or CoolSelecting Your Desired 1200 Am Setting the ClockSelect Mode by Pressing the Mode Button Selecting the Heat or Cool ModeAuto or Program Mode Selecting Your Desired Temperature adjusting the setpointsSetting the Clock Setting the Clock Contents Programmable or Non-Programmable Thermostat Press Setup button to enter Setup screensManual or Auto-Changeover Thermostat Operating Mode when the Thermostat is Configured to be Cooling Only Time Schedule for Programmable with Auto-Changeover If the thermostat is Selecting Your Desired Temperature adjusting setpoints Viewing the Outdoor Temperature Viewing the Outdoor Temperature Schedule Programming a Daily600 Programming a Daily Schedule800 1000 Delay Using the Fan Button Setting the Fan-Off TimeUsing the Fan Button 003 Setting the Fan-Off Time DelayContents Turning On/Off the Backlight 1200 Locking/Unlocking the KeypadProgramming Run-Time Alerts How to Set and Reset the Service Filter Fan Run-Time Alert Until this setup screen appears How to Set and Reset the UV Light Run-Time AlertElectric Heat and Heat Pump Operation Viewing the Heat Pump Reversing Valve Jumper Settings Viewing the Electric Heat Jumper Setting Using Emergency Heat 11.3 Adjusting the Deadband 11.4Adjusting the Heat/Cool Differential Adjusting the Cycles Per Hour Adjusting the Deadband Adjust the deadband for the 1st stage 12.3 1200 Pm Calibrating the Temperature and Humidity SensorsAccessories Advanced Setup Index Heat Manual Time Schedule 88-746 Rev Factory Default Settings for default values see Resetting the Thermostat to