Goodman Mfg TSTATG2111 owner manual 4Z95

Page 2

Air Conditioning & Heating

CAUTION

Follow the Installation Instructions before proceeding. Set the thermostat mode to “OFF” prior to changing settings in setup or restoring Factory Defaults.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

4Z95

Thermostat TSTATG2111

FCc Tested to Comply with FCC Standards

FOR HOME OR OFFICE USE

Page i

Image 2
Contents Owner’ ’sManual l 4Z95 How to Use This Manual Glossary of Terms Table of Contents Contents Heat Front PanelDisplay Features CoolService Filter icon Section Selecting Your Desired Setting the Clock Selecting the Heat or CoolUsing the Fan Button Setting the Clock 1200 AmSelecting the Heat or Cool Mode Select Mode by Pressing the Mode ButtonSelecting Your Desired Temperature adjusting the setpoints Auto or Program ModeSetting the Clock Setting the Clock Contents Press Setup button to enter Setup screens Programmable or Non-Programmable ThermostatManual or Auto-Changeover Thermostat Operating Mode when the Thermostat is Configured to be Cooling Only Time Schedule for Programmable with Auto-Changeover If the thermostat is Selecting Your Desired Temperature adjusting setpoints Viewing the Outdoor Temperature Viewing the Outdoor Temperature Programming a Daily ScheduleProgramming a Daily Schedule 600800 1000 Using the Fan Button Setting the Fan-Off Time DelayUsing the Fan Button Setting the Fan-Off Time Delay 003Contents Turning On/Off the Backlight Locking/Unlocking the Keypad 1200Programming Run-Time Alerts How to Set and Reset the Service Filter Fan Run-Time Alert How to Set and Reset the UV Light Run-Time Alert Until this setup screen appearsElectric Heat and Heat Pump Operation Viewing the Heat Pump Reversing Valve Jumper Settings Viewing the Electric Heat Jumper Setting Using Emergency Heat Adjusting the Deadband 11.4 11.3Adjusting the Heat/Cool Differential Adjusting the Cycles Per Hour Adjusting the Deadband Adjust the deadband for the 1st stage 12.3 Calibrating the Temperature and Humidity Sensors 1200 PmAccessories Advanced Setup Index Heat Manual Time Schedule 88-746 Rev Resetting the Thermostat to Factory Default Settings for default values see