Goodman Mfg TSTATG2111 owner manual Calibrating the Temperature and Humidity Sensors, 1200 Pm

Page 49

Air Conditioning & Heating

Calibrating the Temperature and Humidity Sensors

Under normal circumstances it will not be necessary to adjust the calibration of the temperature and humidity sensors. If calibration is required, please contact a trained HVAC technician to correctly perform the following procedure.

			12:00 Pm
	MODE	Place the thermostat in the		72
	MODE	OFF mode.	OFF
		OFF mode.	OFF

12

	Press	and hold		Am Program On Setup
	Press	and hold	the MODE 18:88 Pm StartStop		HI	88
MODE	button.	While holding the		SuMoTuWeThFrSa DeHumidify	HI
MODE	button.	While holding the		Service Filter
	MODE button, press and hold			Pan UV Light		COOL
	MODE button, press and hold			AUTO	Outside
	the FAN button for 5 seconds.			OFFON	Vacation
	All icons will appear on the			Morning	AUXHEAT
	display.			DayNight	LO
	display.			Evening
				FanOn188 88
PRESS
THERMOSTAT SENSOR
Press the UP and DOWN buttons				72
at the same time twice.			The			CALIBRATE
thermostat	temperature will		be
displayed and may be calibrated
using the UP or DOWN buttons.
TWICE

After calibration is complete, press the MODE button once to return to normal operation.

Page 12.3

Image 49

Contents Owner’ ’sManual l 4Z95 How to Use This Manual Glossary of Terms Table of Contents Contents Front Panel HeatCool Display FeaturesService Filter icon Section Using the Fan Button Setting the Clock Selecting the Heat or CoolSelecting Your Desired 1200 Am Setting the ClockSelect Mode by Pressing the Mode Button Selecting the Heat or Cool ModeAuto or Program Mode Selecting Your Desired Temperature adjusting the setpointsSetting the Clock Setting the Clock Contents Programmable or Non-Programmable Thermostat Press Setup button to enter Setup screensManual or Auto-Changeover Thermostat Operating Mode when the Thermostat is Configured to be Cooling Only Time Schedule for Programmable with Auto-Changeover If the thermostat is Selecting Your Desired Temperature adjusting setpoints Viewing the Outdoor Temperature Viewing the Outdoor Temperature Schedule Programming a Daily600 Programming a Daily Schedule800 1000 Delay Using the Fan Button Setting the Fan-Off TimeUsing the Fan Button 003 Setting the Fan-Off Time DelayContents Turning On/Off the Backlight 1200 Locking/Unlocking the KeypadProgramming Run-Time Alerts How to Set and Reset the Service Filter Fan Run-Time Alert Until this setup screen appears How to Set and Reset the UV Light Run-Time AlertElectric Heat and Heat Pump Operation Viewing the Heat Pump Reversing Valve Jumper Settings Viewing the Electric Heat Jumper Setting Using Emergency Heat 11.3 Adjusting the Deadband 11.4Adjusting the Heat/Cool Differential Adjusting the Cycles Per Hour Adjusting the Deadband Adjust the deadband for the 1st stage 12.3 1200 Pm Calibrating the Temperature and Humidity SensorsAccessories Advanced Setup Index Heat Manual Time Schedule 88-746 Rev Factory Default Settings for default values see Resetting the Thermostat to