Steps | Figures | Explanation |
Step 18. |
| Tighten screws. |
Insert screws (6 x 95 mm) to the Operating Arm on
Step 19.Square See the figure presented for a out-swing door (Right-Hand Open), more details shown in Figure 9.
Step 20. | Tighten nut at other end of screw. |
Step 21. | Use the 10mm wrench to tighten nuts. |
Step 22. | Insert pin to avoid the screws from loosing. |
Step 23. | Slide the Operating Arm to Sliding Rail. |
Copyright All Rights Reserved. |
|
Page: 15/ 20 |