Hearth and Home Technologies CB1200-B owner manual Glass Replacement, Replacing Side Glass Screws

Page 34

CB 1200 Pellet Stove			R
CB 1200 Pellet Stove
H. Glass Replacement
	WARNING		Door Latch
	• Glass is 5mm thick high temperature heat-	Top & Bottom Frame
	resistant ceramic glass.	Top & Bottom Frame
	resistant ceramic glass.
	• DO NOT REPLACE with any other material.
	• Alternate material may shatter and cause
	injury.	Center Posts
		Center Posts
	• Remove door from appliance and place face down		Side
	on a protected surface to avoid scratching the door.	Glass	Side
	on a protected surface to avoid scratching the door.		Frame
	• Remove all door rope.		Frame
	• Remove all door rope.
1.	Replacing Center Glass
NOTE: DO NOT LET Air Wash Spacers fall down from
	top frame when removing and replacing center
	glass.

a.Be sure the appliance is allowed to cool, has been Figure 34.1 unplugged and the exhaust blower is off.

b. Using a nut driver remove the (5) bottom nuts and remove the bottom glass frame. Figure 34.2.

c.Slightly bend up and out of the way the 2 center posts and slide the glass out the bottom.

d.Slide new glass in, reposition the 2 center posts and re-install bottom glass frame.

e.Re-rope the door.

2.Replacing Side Glass

NOTE: When removing the side glass with the door latch, you must remove the door latch ﬁrst before removing the side frame. Use a pow- ered Phillips head screw driver to remove the

4screws.

a.Be sure the appliance is allowed to cool, has been unplugged and the exhaust blower is off.

b.Remove side glass frame.

c.Loosen the top and bottom frame and slightly bend up and out of the way.

d.Slide glass out the side and slide new glass in.

e.Re-install the side glass frame and tighten the top and bottom frames.

f.Re-install the door latch, if applicable, and re-rope the door.

Remove Door Latch First

and then Side Frame

Door Frame

shown with no

Glass or Glass

Frames

Remove 5 nuts from Bottom Frame

Figure 34.2

WARNING

Handle glass with care.

• Inspect the gasket to ensure it is undamaged.

• Do NOT strike, slam or scratch glass.

•Do NOT operate appliance with glass assembly removed.

•Do NOT operate with glass cracked, broken or scratched.

Page 34

7014-082D

September 1, 2008

Image 34

Contents Classic BAY 1200 Pellet Stove Hot glass will cause burnsCB 1200 Pellet Stove Testing Lab & Report Number Serial Number Model Mfg DateBehind left side curtain on outside of hopper wall Table of Contents Listing and Code Approvals Getting Started Design, Installation & Location ConsiderationsFire Safety Appliance LocationCB 1200 Pellet Stove Tools And Supplies Needed Inspect Appliance & Components and Pre-Use Check List3Dimensions and Clearances Appliance DimensionsCB 1200 Pellet Stove Clearances to Combustibles UL and ULC CB 1200 Pellet Stove Hearth Pad Requirements UL and ULC Exception for Horizontal InstallationsHearth Pad Requirements 4Vent Information Example of 3 Elbow-Rear Vent Termination Calculaton Pipe Selection ChartCB 1200 Pellet Stove Equivalent Feet of Pipe Example5Venting Systems AlcoveDegree Straight OutCB 1200 Pellet Stove Through The Wall CB 1200 Pellet Stove Vertical Through The Wall & VerticalMasonry Alternate Masonry6Mobile Home 7Appliance Set-Up Rear Installation Floor InstallationOutside Air Kit Instructions Installing the Top Vent Adapter CB 1200 Pellet Stove Top Vent Adapter InstallationRear Vent and Rear Vent to Top Vent Adapter Installation See FigureInstalled Clip Top Log, Left Installing Logo Nickel OnlyCharred Areas in the Back RightTo install door CB 1200 Pellet Stove Door InstallationThermostat Installation To adjust latches8Operating Instructions Fuel Size And Material General Operating InformationFeed Rate Adjustment Instructions Starting Your First FireButton. See .1, page 22 . When you press Frequently Asked QuestionsCB 1200 Pellet Stove Ignition Cycles Symptom TroubleshootingPossible Cause Corrective Action Page Page 10Maintaining & Servicing Your Appliance Quick Reference Maintenance ChartCleaning or Inspection Frequency Daily Weekly Monthly YearlyCleaning Heat Exchanger Chambers & Drop Tube Cleaning Firepot with Cleaning Rod & Firepot ScraperCleaning Ash Pan Ash Removal from FireboxCleaning the Hopper Cleaning the Glass Cleaning Beneath Heat Exchanger Door Latch InspectionCleaning Exhaust Path Cleaning Exhaust Blower Requires No LubricationCleaning the Top Vent Adapter Preparing Firebox for Non-Burn Season Frequency YearlyCB 1200 Pellet Stove High Ash Fuel Content Maintenance Convection Blower ReplacementInstall new blower Exhaust Blower Replacement Remove existing blowerRe-install blower to blower housing Glass Replacement Replacing Side Glass ScrewsReference Materials Component Function & LocationSnap Disc #1 Convection Blower 145F Vacuum SwitchWiring Harness See .1 below Snap Disc #2 Thermostat Override 200FCB 1200 Pellet Stove Component Locations Glass Size Center 13-7/8 wide x 11 high CB 1200 Pellet Stove Exploded ViewsGlass Size Sides 8 wide x 11 high Nbr Description CB 1200 Pellet Stove CB 1200 Pellet Stove Service Parts and Accessories Item # Parts Alphabetical OrderItem # Service Parts Alphabetical Order Accessories ApplianceCB 1200 Pellet Stove Service And Maintenance Log Date of Service Performed By Description of ServiceCB 1200 Pellet Stove Homeowner’s Notes CB 1200 Pellet Stove Warranty Policy CONDITIONS, Exclusions & Limitation of LiabilityHearth & Home Technologies Limited Warranty Cont’d Contact Information