Husqvarna E20 Presser Foot Shank, Attaching the presser foot shank, Removing the presser foot

PRESSER FOOT SHANK

Attention: Turn power switch to “O” before carrying out any of the operations below.

Attaching the presser foot shank:

Raise the needle to its highest position and raise the presser foot lever. Attach the presser foot shank (b) to the presser foot bar (a). (1)

Attaching the presser foot:

Lower the presser foot shank (b) until the cut-out (c) is directly above the pin (d). (2)

Lower the presser foot shank (b) and the presser foot

(f) will engage automatically.

Removing the presser foot:

Raise the presser foot.

Release the pressure foot by raising lever (e) located at the back of the presser foot shank. (3)

Attaching the seam guide:

Attach the seam guide (g) in the slot on the shank as illustrated. Adjust the distance as required for hems, pleats, quilting, etc. (4)

11