Husqvarna E20 manual Changing the Needle System 130/705H

Page 14

CHANGING THE NEEDLE (SYSTEM 130/705H)

Caution: Turn power switch to “O” before inserting or removing the needle.

Replace the needle at the ﬁrst sign of thread breakage or skipped stitches. Select the correct type and size of needle for the fabric to be sewn. Turn the hand wheel towards you until the needle is at highest position. Loosen the needle clamp screw (A) and tighten again after inserting the new needle. (1)

The ﬂat side of the needle shaft should be facing toward the back (B).

Push the needle up (C) into the needle clamp as far as it will go (D).

Tighten the needle clamp screw ﬁrmly.

The sewing needle must always be straight and sharp for smooth sewing. Replace the needle (2) if it is bent (A), blunt (C) or the point is damaged (B).

14

Image 14

Contents E20 Important Safety Instructions Contents Principal Parts Page Accessories Slide on the SNAP-IN Accessory BOX Connecting the Machine to Power Source For the USA and CanadaChanging the Bulb Replace bulb with same type rated WattsAdjusting the Presser Foot Pressure TWO-STEP Presser Foot Lever Attaching the presser foot Presser Foot Shank Attaching the presser foot shank Removing the presser footWinding the Bobbin Inserting the Bobbin Changing the Needle System 130/705H Threading the Upper Thread Bringing UP the Bobbin Thread Thread Tension Upper thread tensionRaise or Lower the Feed DOG Removing the Fabric Reverse SewingChanging Sewing Directions Cutting the ThreadHOW to Choose Your Pattern Matching Needle / Fabric / Thread Needle, fabric, thread selection guideFunction of stitch length dial while zigzaging ZIG ZAG SewingFunction of stitch width dial Satin stitchStraight Stitching and Needle Position Double overlock stitch Overlock StitchesSeams, overcasting, visible hems Standard overlockBlind HEM Making a Buttonhole on Stretch Fabrics E ONE Step ButtonholesMaking a Buttonhole Left and Right Side Balance for Buttonhole Zippers and Piping Joining fabric Step ZIG-ZAGSewing elastic Triple zig-zag 2/4 Stretch Stitch SelectionTriple straight stitch 1/3 Free Motion Darning Darning Quilting Cleaning and lubricating the hook MaintenanceCleaning the feed dog Remove the stitch plateTroubleshooting Guide Problem Cause CorrectionVSM Group AB SE-561 84 Huskvarna Sweden