INSERTING THE BOBBIN
Attention: Turn power switch to “O” before inserting or removing the bobbin.
When inserting or removing the bobbin, the needle must be fully raised.
-Open the hinged cover. (1)
-Hold the bobbin case with one hand. Insert the bobbin so that the bobbin runs in a clockwise direction (arrow). (2)
-Pull the thread through the slot, down and to the left until it enters the delivery eyelet (rectangular opening) under the tension spring. (3)
-Hold the bobbin case by the hinged latch. (4)
-Insert the bobbin case fully into the shuttle race and release the latch. Make sure that the metal finger fits into the notch at the top of the race cover. (5) Push on the bobbin case to be sure it is clicked in completely.
13