c)Setting the presser foot pressure
Here you can set the pressure with which the material is pressed onto the stitch plate.
•Using the little screwdriver supplied, loosen the screw at the top of the front cover.
Open the front cover.
Now use the lever to set the presser foot pressure, for example
"0" if no pressure is to be applied, for example for darning with free- hand stitches
"1" for light fabrics (curtains) "2" for average fabrics (normal) "3" for heavy fabrics.
d)Stitch width
Here you can set the width of seam for zigzag patterns.
First raise the needle fully, by turning the handwheel.
Select a stitch width from 0...5 using the selector wheel (0 = narrow /
5 = wide)
Important: If the twin needle has been inserted, the selector wheel should be set to "3" maximum. If a higher setting is selected, the twin needle will break!
e)Stitch length
Here you can set the speed at which the material is carried forward when sewing. This therefore determines the gap (length) between the stitch points.
Select a stitch length on the stitch length selector wheel (0 = short / 4 = long).
15