Kompernass E-2073 manual Sewing on buttons, Edge-to-edge stitching

Page 24

n)Sewing on buttons

Attach the button foot

Place the darning plate on top of the zigzag plate, as described in Chapter 8.

Place the button between the button foot and the cloth, and lower the but- ton foot.

•Turn the flywheel anticlockwise by hand. Check whether the needle passes cleanly through both button holes.

•If necessary, slightly adjust the stitch width of the zigzag pattern.

•If the sewing machine can sew both buttonholes in manual mode, you can now carefully sew 5-7 stitches with the machine by carefully pressing the foot switch.

o)"Edge-to-edge" stitching

Select the "Three-step zigzag stitch" ("D") or the honeycomb stitch ("J") as stitch pattern.

24

Image 24

Contents Page Automatic Free-Arm Sewing Machine 270 E Contents Technical DataContent of package Intended UseProvide adequate lighting when working Setting up Switching On / OffThreading Threading the lower thread Under the tension spring Close the gripper flap Threading the upper thread Then over the threading hookRetrieving the lower thread Attaching accessories Threading with 2 needlesChanging needles Changing the sew foot Changing the stitch plateButtonhole foot Blind hem foot Button foot Zipper foot Settings Setting the upper thread tensionSetting the lower thread tension Setting the presser foot pressure Stitch widthStitch length Open the front coverSewing To place the materialTo start a seam To finish off a seamGuiding the material Changing the sewing directionSelecting a stitch pattern Straight stitchZigzag Set the stitch length Select the stitch widthSewing stitch pattern selector & sewing table accoutrements Blind hem Material-Thread-Needle-Table Please refer to the details for the various materialsSeam guide Overcast stitchStretch seam Sewing buttonholes Attach the button hole foot, as described in ChapterSewing on buttons Edge-to-edge stitchingSewing a zipper Sewing with the twin needle EmbroideryThread cutter Clean the gripper area Clean the feederCare Open the gripper coverClean the casing Oil the gripper trackWhat else needs oiling? StoringIs there a problem? Fault / Problem Check Possible remedyWarranty and service DisposalIf the bulb no longer comes on