Kompernass E-2073 manual Blind hem

Page 20

i)Blind hem

Fold the material as shown. Make the fold as wide as you want the fin- ished seam to be: the bottom fold should be about 5 mm away.

Use the blind hem foot. While sewing, check the seam width and needle setting, to ensure that the seam remains uniform.

Sew the blind seam on the underside of the material, so that only the peak of the zigzag stitch pierces the out- side of the material. When you have finished sewing, push the left of the material over to the right and smooth out. The seam is almost invisible!

The table below shows the suggested settings for the various values, depend- ing on the material used.

20

Image 20

Contents Page Automatic Free-Arm Sewing Machine 270 E Contents Technical DataContent of package Intended UseProvide adequate lighting when working Setting up Switching On / OffThreading Threading the lower thread Under the tension spring Close the gripper flap Threading the upper thread Then over the threading hookRetrieving the lower thread Changing needles Attaching accessoriesThreading with 2 needles Buttonhole foot Blind hem foot Button foot Zipper foot Changing the sew footChanging the stitch plate Setting the lower thread tension SettingsSetting the upper thread tension Setting the presser foot pressure Stitch widthStitch length Open the front coverSewing To place the materialTo start a seam To finish off a seam Guiding the material Changing the sewing directionSelecting a stitch pattern Straight stitchZigzag Set the stitch length Select the stitch widthSewing stitch pattern selector & sewing table accoutrements Blind hem Material-Thread-Needle-Table Please refer to the details for the various materialsStretch seam Seam guideOvercast stitch Sewing buttonholes Attach the button hole foot, as described in ChapterSewing on buttons Edge-to-edge stitchingSewing a zipper Thread cutter Sewing with the twin needleEmbroidery Clean the gripper area Clean the feederCare Open the gripper coverClean the casing Oil the gripper trackWhat else needs oiling? StoringIs there a problem? Fault / Problem Check Possible remedyIf the bulb no longer comes on Warranty and serviceDisposal