Kompernass E-2073 manual Sewing buttonholes, Attach the button hole foot, as described in Chapter

Page 23

m) Sewing buttonholes

Attach the button hole foot, as described in Chapter 8.

• Refer to the table for:

- the required stitch length

- the required stitch pattern

- the required procedure for sewing.

You can now cut into the center of the button hole, as shown.

Pattern selector				Procedure	Settings/Stitch length
(stitch pattern)

H					1.	Set selector to "1"
					1.	Set selector to "1"
					2. Sew left side
					3.	Raise needle


					4.	Set selector to "2"
					4.	Set selector to "2"

G	5. Sew 5-6 stitches

6.Raise needle

7.Set selector to "3"


F	8.	Sew right side
	9.	Raise needle
G	10.		Set selector to "4"
	11.		Sew 5-6 stitches
	12.		Raise needle

23

Image 23

Contents Page Automatic Free-Arm Sewing Machine 270 E Intended Use ContentsTechnical Data Content of packageProvide adequate lighting when working Switching On / Off Setting upThreading Threading the lower thread Under the tension spring Close the gripper flap Then over the threading hook Threading the upper threadRetrieving the lower thread Changing needles Attaching accessoriesThreading with 2 needles Buttonhole foot Blind hem foot Button foot Zipper foot Changing the sew footChanging the stitch plate Setting the lower thread tension SettingsSetting the upper thread tension Open the front cover Setting the presser foot pressureStitch width Stitch lengthTo finish off a seam SewingTo place the material To start a seamChanging the sewing direction Guiding the materialSet the stitch length Select the stitch width Selecting a stitch patternStraight stitch ZigzagSewing stitch pattern selector & sewing table accoutrements Blind hem Please refer to the details for the various materials Material-Thread-Needle-TableStretch seam Seam guideOvercast stitch Attach the button hole foot, as described in Chapter Sewing buttonholesEdge-to-edge stitching Sewing on buttonsSewing a zipper Thread cutter Sewing with the twin needleEmbroidery Open the gripper cover Clean the gripper areaClean the feeder CareStoring Clean the casingOil the gripper track What else needs oiling?Fault / Problem Check Possible remedy Is there a problem?If the bulb no longer comes on Warranty and serviceDisposal