Enviro 1700 Insert, C-11116, 1200 Insert, 1700 Fireplace Freestanding Any area within 10 feet

								Installation
and in any area within 10 feet											Rain cap/
(304.8 cm) of the roof ridge,
											Spark arrestor cap
the chimney must be 2 feet										Roof radiation	Storm Collar
(60.9		cm)	above		the		ridge.				Roof flashing
Refer to Figure 24.									shield (if required)
											Roof
Note:	Increasing			the		chimney
									Insulated chimney
height above the roof may
help your unit to draft better.
This greater draft can decrease
problems			such		as	difficult		Ceiling	Minimum		Minimum air space
start-ups, smoke					coming out				18" (475 mm)
											in accordance with
when door is open, and dirty											chimney manufacturer.
glass. You may initially try											Insulated corner
the minimum required height
and if problems do arise, add
additional height later.										Chimney	Wall support
10. Slide the			roof	flashing			over			connector	Chase
your chimney and seal the
											(optional)
flashing to the				roof		with a		Woodstove		Optional
roofing compound. Secure the										fan
roof flashing to your roof with
nails or screws.									Pedestal
11. Place the storm collar over the								Hearthpad
flashing and seal the joints
with silicone caulking.
12. Fasten		the	rain	cap		/	spark	Floor	Outside air connection
arrestor cap to the top of your
									through wall or floor
chimney.								Figure 26: Standard Horizontal Installation.
13. Place		the	stove		back		into
position.

14.Install the chimney connector pipe with the lower (crimped) edge of the pipe inside the flue collar. Any creosote formed will then run back down into the stove. All connections must be tight and secured with three sheet metal screws equally spaced. Double wall pipe is recommended over single wall.

15.Also install an outside air flex pipe to the stove.

IMPORTANT: When a metal prefabricated chimney is used, the manufacturer’s installation instructions must be followed. You must also purchase and install the ceiling support package or wall pass-through and “T” section package, firestops (where needed), insulation shield, roof flashing, chimney cap, etc. Maintain proper clearance to the structure as recommended by the manufacturer. The chimney must be the required height above the roof or other obstructions for safety and proper draft operation.

Note: If you are using a horizontal connector (refer to Figure 26), the chimney connector should be as high as possible while still maintaining the 18” (475 mm) minimum distance from the horizontal connector to the ceiling.

26