Installation
Please read and understand these instructions before installing pedestal or ash pan and leg option. Failure to follow these instructions carefully could cause personal injury or property damage. All screws are
REMOVAL FROM PALLET:
• Remove the bricks from the unit before starting.
• Remove the two (2) carriage bolts (shown in Figure 15) that secure the unit to the pallet from inside the firebox.
Figure 14: |
Rivet. |
Note: After the pedestal or legs and ash pan have been installed but before the bricks are installed, rivets (Figure 14) must be placed in the two (2) holes (shown in Figure 15) in the firebox that carriage bolts came out of. This is done to make unit burn more efficiently. The shoulder rivets are found in the manual bag.
Figure 15: Bolts to remove.
PEDESTAL INSTALLATION - FREESTANDING:
• Place the unit on the pallet on its back.
• Slide the pedestal assembly over the bolts located on the base of the unit using the key- holed slots provided.
• Tighten all four (4) bolts ensuring the pedestal is properly aligned to the edges of the unit.
• Stand the unit on the pedestal and set the unit in the location ready for installation.
• If fresh air supply is being supplied from the bottom of the unit please install the cover plate supplied to the rear of the pedestal covering the 4 inch (10 cm) hole.
Note: In seismically active areas, it is recommended that your unit is secured to the floor by using the
Figure 16: Installing Pedestal.
21