Enviro 1200 Fireplace Freestanding, C-11116, 1700 Insert Operating Instructions, First Start

Page 4
Figure 2: Installing Ash Drawer.

Operating Instructions

FIRST START

When first installed, the chimney, firebricks and steel are cold and it usually takes several hours on a fairly high burn for them to become hot and dry enough for the stove to function well. We recommend during the unit’s first burn that a door and window are opened to vent the smoke and fumes created from the unit’s paint curing. The paint will smell a little for the first burn or two as it cures.

FANS:

All models have been approved for operation with or without the optional fans supplied by the manufacturer. On medium or high burns, using a fan will increase the heat transfer slightly. Route the power supply cord along the floor behind the stove where it will remain cool.

DISPOSAL OF ASHES:

If you let the ashes accumulate two or three inches on the floor they tend to burn themselves up.

The fireplace insert models do not have and ash drawer so the ashes will need to be scooped into a metal container with a tightly fitting lid. Place the closed container on a non-combustible floor, well away from combustible materials.

The freestanding models are equipped with a small tap door in the firebox and an ash drawer. Open

the trap door located on the floor of

 

 

the unit. Push the ashes that have

 

 

accumulated into the hole were the

 

 

ashes would drop into the ash pan.

 

 

Ensure that the trap door is closed

 

 

properly before relighting the unit.

 

 

When the ash drawer is ready to be

 

 

emptied lift the front of the drawer up

 

 

then slowly pull the drawer straight out

Open

Closed

and close the lid on the ash drawer

 

 

(see Figure 1); this is to prevent

Figure 1: Ash Drawer Lid Open and Close.

making a mess with the ashes when

 

 

transporting the ash drawer through

 

 

the house. When re-installing the ash

 

 

drawer ensure that the lid is open and

 

 

line up the rails on the bottom of the

 

 

ash drawer with the notches in the

 

 

opening on the pedestal (see Figure 2).

 

 

Slide the drawer into place, the front of

 

 

the drawer will drop a bit when it is all

 

 

the way in.

 

 

If the ashes are to be buried in soil or otherwise locally dispersed, keep them in a closed container until all cinders have cooled. Small amounts of cold wood ash can be used in the garden or compost.

4

Image 4
Contents Wood Stove Table of Contents Safety Precautions Operating Instructions First StartReplacing the Glass Maintenance Helpful Hints Worth Repeating What does dry, seasoned wood mean? Air Control Rod 1200 Air Flow Path Specifications Capacity Feet3 0.0708 meter3 Approximate heating area † From front of door opening to edge of floor protection Maintain These Minimum Clearances to Unshielded Combustibles 1700 Freestanding Clearance to Combustibles 1200 Insert Dimensions 1700 Insert Dimensions 1200 Freestanding Flat Top Dimensions 1700 Freestanding Flat Top Dimensions 1200 Freestanding with Fan Kit Dimensions Installation Bolts to removeInstalling Heat Shield Recommended Height for Flue Pipe Chimney Through Wall Method a Roof Clearances Any area within 10 feet Installation into a masonry chimney Venting Outside AIR Insert Installation into existing fireplace with Hearth Metal TAG this Fireplace has Been Before starting this type of installation 3D of Dimensions needed from Fireplace Insert Install into a Zero-Clearance Fireplace Total Bricks Tube C Tube B Tube a Do not USE Door if Glass is Broken Installation of Ceramic Baffle Back View of Freestanding Unit with Fan Kit Removal of right Pod Installation of Trim Parts List EFW-264 PartsDiagramFreestanding Parts Diagram Pedestals & Legs Parts Diagram Fireplace Insert Warranty Limited Five 5 Year Warranty Limited One 1 Year WarrantyExclusions and Limitations Warranty Installation Data Sheet