To Supply Power to the Exhaust Blower

Installation

9.Connect the wires in the stove. Re-install the left side access cover to the stove and the back grill on the exterior vent housing.

10.Set the Slider Damper as described in the INSTALLATION - SLIDER/DAMPER SETTING“ section.

NOTE:

Ensure that all vent connections are installed by placing three (3) screws evenly spaced and a small bead of high temperature silicone at each chimney connection. Also ensure that all vertical vent sections are properly supported and that all clearances to combustibles are maintained in accordance with the vent manufacturer’s specifications.

Vent termination cap

Siding

(stainless steel termination

hood) or 45° elbow with

rodent screen

Wall strap

(recommended with

use of vent pipe)

Vent pipe or 610mm (2 foot) riser

Pipe adapter (if using riser)

Exterior blower and housing

Horizontal frame for thimble

Armour cable supplying power to exterior blower

90° elbow

Wall framing

Wall thimble

Figure 19: Exhaust Blower Installation; Horizontal Termination.

TO SUPPLY POWER TO THE EXHAUST BLOWER:

Install an amour coated electrical cable from the exhaust blower housing, through the wall thimble, and attach to the pre-drilled hole in the left hand rear hopper pillar. Hook up to wires from the wiring harness for the exhaust blower. All electrical connections must be in accordance with local code requirements (see

WIRING DIAGRAM).