Harman Stove Company PC 45 manual Installing, Mobile Home Installation

Page 6

Installation

Installing

Place the stove on a noncombustible floor protec- tor that extends 6 inches to the front, 6 inches to the sides and 1 inch to the rear of the stove. The minimum floor protector material is 24 gauge sheet metal.

Place the stove away fromcombustible walls at least as far as shown in figures 6,7 & 8. Please note the differ- ence in side wall clearance with and without side shields.

Note that the clearances shown are minimum for safety but do not leave much roomfor access when clean- ing or servicing. Please take this into account when plac- ing the stove.

Connect the power cord to a 120 V.A.C. 60Hz grounded receptacle. (A surge protector is recommened to protect the circuit board).

Prior to installing the flue pipe, connect a draft meter to the stove as shown in fig. 9. (The draft meter must

 

9"-13"

 

9"-13"

9" With Side Shields

 

13" WithoutSide Shields

Fig. 6

 

1"

2"

have a minimum range of 0"- 0.5"). Turn stove to "TEST" Mode and record the draft reading ______. After the flue

pipe is connected, check the draft reading again making sure all doors and windows in the home are closed. If this reading is more than.05" higher thanthe unconnected reading, check for possible restrictions or the need for outside air. (See page 8).

Mobile Home Installation

When installing this unit in a mobile home several requirements must be followed:

1. The unit must be boltedto the floor. This canbe done

with 1/4" lag screws through the 2 holes in the base plate.

2. The unit must also be connected for the outside

air. See page 8.

3. Floor protection and clearances must be followed

6"

FLOOR PROTECTOR

6"

 

 

 

Fig. 7

6"

10"

With Side Shields

as shown.

4. Unit must be grounded to the metal frame of the

mobile home.

CAUTION:This appliance must be vented tothe out-

side.

Duetohigh temperatures,the stoveshouldbeplacedout oftraffic

andaway fromfurniture anddraperies.

Children and adults should be alerted to the haz-

ards of high surface temperatures and should stay away

to avoid burn to skin and/or clothing.

Young children should be carefully supervised when

they are in the same room as the stove.

Clothing and other flammable materials should not

be placed on or near this unit.

Installation and repair of this Harman Stove should

be done by a qualified service person. The appliance

should be inspected before use and at least annually by a

qualified service person. More frequent cleaning will be

required. It is imperative that control compartments, burn-

ers, and circulating air passageways of the stove be kept

clean.

Mobile home installation should be done in accordance

with the Manufactured Home and Safety Standard (HUD),

CFR 3280, Part 24.

6 PC 45 Corn/Pellet Stove

18"

Side Shields

FLOOR PROTECTOR

Without

Fig. 8

 

Fig. 9: Refer to page 18 for detailed draft settings and adjustment procedures.

Image 6
Contents Installation & Operating Manual Harman PC 45 Corn/Pellet StovePC 45 Corn/Pellet Stove Table of Contents IntroductionUnpacking Assembly and InstallationInstalling rear cover panels FirebrickDoor Assembly/Installation Tips Assembling the doorInstallation InstallingMobile Home Installation With outside air installed With outside air installed, 6 feetVenting Vent Pipe Outside Air#1 Preferred method #2 Preferred method#3 Installing into an existing Chimney US only #4 Installing into an existing fireplace chimney US only#6 Installing into an existing chimney US and Canada #7 Installing through the ceiling vent Minimumflue vent configurationIgniter switch to Auto Stove Temperature ModeAutomatic IGNITION/OPERATION Automatic Start UP Starting the FireManual Stove Temperature Mode Igniter Switch to Manual Manual IGNITION/OPERATIONBurning Corn Shut-Down ProcedureManual Start UP Burning PelletsStatus light error messages Automatic Ignition ESP ControlLow Draft Voltage Adjustment Low Draft Voltage AdjustmentMaintenance CleaningRemoving Ashes Cleaning of Feeder Fines Area Soot and Fly AshMaintenance Burn Pot Burn Pot Cleaning and MaintenanceCleaning of Burnpot Parts Helpful Hints PC 45 Trouble-ShootingCleaning Burn Pot FuelFeeder and Specifications SpecificationsCleaning Gold Door OptionsSunrise Gold Trim Gold Door Side Heat Shields Room Sensor Installation Hopper ExtensionOptions Optional Pellet Burnpot GratePC 45 Wiring Diagram PC 45 Parts List Description Part NumberYear Limited Warranty Commercial