Automatic Start UP, Starting the Fire | Harman Stove Company PC 45

AUTOMATIC START UP

Fig. 23

14 PC 45 Corn/Pellet Stove

Starting the Fire

Igniter Switch to"AUTO"(up position)

Make sure the unit is plugged into a 120 VAC, 60 HZ electrical source. The power light should be the only light lit. Anytime there is interruption in power at the receptacle, the combustion blower will run for 1 minute after the power is regained.

1.Turn the Mode Selector to "OFF"

2.Fill the hopper with corn or pellets.

3.Clean the burn pot and housing, if necessary.

4.If starting after an empty hopper, turn the feed adjuster to "TEST" until the fuel is visible in the auger tube opening. This also allows you to check the motors for operation.

NOTE: The auger motor will not operate with the view door or ash door open.

NOTE: The initial start-up on a new stove may require the corn to be purged into the burnpot area before continuing to step 5.

5.Turn the feed adjuster to #2 (corn) or #4 (pellet)

6.Flip the igniter switch up into the "AUTO" position.

7.Turn the temperature dial to the desired room temperature.

8.Turn the mode selector dial to Room Temperature or Stove Temperature.

9.Fill the hopper with corn or pellets and remove the ashes as required.

Warning

"NEVER USE GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER FLUID, OR SIMILAR LIQUIDS TO START OR "FRESHEN UP " A FIRE IN THIS HEATER. KEEP ALL SUCH LIQUIDS WELL AWAY FROM THE HEATER WHILE IN USE".