
HY-013 SERIES ASSEMBLY INSTRUCTIONS
NOTE: Remove all contents from the box being careful not to discard the manual and hardware needed for assembly. A phillips head screw driver ( ) is required for assembly and is not included with the fan purchase.
A. Pedestal Assembly
•Place the power cord through the center of the front and rear pedestal assemblies with the screw hole openings facing towards the fan.
•Align the front and rear pedestal assembly and firmly snap together (Fig 7).
B. Securing the Tower Fan to the Pedestal
•Gently turn fan upside down.
•Line up the 3 screw holes on the pedestal with the 3 screw holes on the bottom of the fan housing. Use the 3 (M5 x 12)
screws included in the box and a phillips head screw driver ( ) to secure the pedestal to the fan housing (Fig. 8).
C. Base Assembly
•With the fan in the upside down position, pass the power cord through the recessed slot located in the center of the rear base assembly (Fig 9).
•Align the rear and front base assembly and firmly snap together by pushing the 4 round extrusion into the adjacent circles of the connecting pieces (Fig 10).
Fig. 9
D. Securing the Tower
Fan to the Base
•Align the 3 screw holes in the bottom of the pedestal with the 3 screw holes located on the base. Using the 3 (M5 x 12) screws and phillips head screw
driver ( ), secure the base into the bottom
portion of the fan housing | Fig. 11 |
(Fig 11). |
|
•Place the power cord through the cut out on the bottom of the base. Gently pull any slack out of the power cord and place the cord securely in the power cord holding bracket (Fig. 12).
•Place the fan right side up. Your fan is now ready for use.
Fig. 7
Fig. 8
Fig. 10
Fig. 12