Hoover U5432900 manual Secondary and final filters, Changing filter bag, Cleaning secondary filter

Changing filter bag

Disconnect cleaner from electrical outlet.

3-1

Removing bag door

To change filter bag, press down at top of bag door and pull door forward.

Remove door.

3-2

B

A

Removing and installing filter bag

Grasp filter bag collar (A) and pull collar from tube (B).

Note: Do not clean out old filter bag and reuse. Discard used filter bag.

Hold new filter bag as shown. Align opening in filter bag with (B).

Push (A) firmly onto (B). Tuck in filter bag.

3-3

C

Replacing bag door

Reposition bag door by placing tabs on bottom of door into opening (C).

Press top of door to snap securely shut.

Secondary and final filters

3-4

A

Cleaning secondary filter

Disconnect cleaner from electrical outlet.

The secondary filter (A), located behind the grill in the bottom of bag compartment, protects the motor from dirt particles.

If filter becomes dirty, pull off grill and lift out filter.

Hand wash filter in cold water with mild detergent, then air dry.

Reposition dry filter and grill.

Should you want to replace this fil- ter, ask for HOOVER part No. 38765019.

3-5

B

Cleaning final filter

The final filter assists in the filtration process to return clean air to the room.

To remove this filter when it be- comes dirty, open the door on the side of the cleaner.

Lift out filter (B) and hand wash it in cold water with mild detergent.

Let filter air dry and reposition it on the side of cleaner. Make sure the green colored side of filter faces outward. Close door.

Should you want to replace this filter, ask for HOOVER part No. 40110004.

Do not operate cleaner without either the secondary or final filter in place.

3-6

C

Reattaching filter door

The filter door is designed with a “break-away” feature which allows it to snap free if it is pushed open too far.

To reattach, align hinges (C) of cover with slots on sides of filter area.

Press door back into place.

Continued ➜ 9