Desa VP1600IT, VP2200IT installation manual Models VP1600C and VP2600C

Page 22

22

OPERATING HEATER

Models VP1600C and VP2600C

Continued

4.Wait five minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information at the top of page 21. If you don’t smell gas, go to the next step.

5.Press in control knob.

Note: You may be running this heater for the first time after hooking up to gas supply. If so, you may need to press in control knob for 30 seconds. This will allow air to bleed from the gas system.

•If control knob does not pop up when released, contact a qualified service person or gas supplier for repairs.

6.Keep control knob pressed in and turn it counterclockwise C-clockwiseto the

PILOT/IGN position. This will light pilot.

Note: You will hear a loud “click” when the control knob reaches the PILOT/IGN position.

If pilot does not light

•turn control knob clockwise Clockwise to the OFF position

•repeat steps 5 and 6

If pilot does not stay lit after several tries

•refer to Troubleshooting, pages 26 through 29

•contact a qualified service person or gas supplier for repairs

Until repairs are made, light pilot with match. To light pilot with match, see Manual Lighting Procedure, page 24 .

Ignitor Electrode

Pilot Burner

Thermocouple

Figure 21 - Pilot

7.Keep control knob pressed in for 30 seconds after lighting pilot. After 30 seconds, release control knob.

Note: If pilot goes out, repeat steps 3 through 7.

100751

Image 22

Contents OWNER’S Operation and Installation Manual What to do if YOU Smell GASContents Safety InformationSafety Information Local Codes FeaturesIdentification UnpackingVentilation Fresh AIR ForCombustion Producing Adequate VentilationDetermining FRESH-AIR Flow for Heater Location Fresh AIRDetermining if You Have a Confined or Unconfined Space Ventilation AIR Fresh AIR for Combustion and VentilationVentilation Air From Inside Building Ventilation AIR Ventilation Air From OutdoorsCheck GAS Type Installing To WallInstallation Items Locating HeaterLocating Thermostat Sensing Bulb Thermostat Sensing BulbModels VP1600IT and VP2200IT Only Attaching Thermostat Sensing BulbRemoving Front Panel Of Heater Installing Heater to WallMounting Bracket Methods For Attaching Mounting Bracket To WallMarking Screw Locations Attaching Mounting Bracket To WallInstalling Bottom Mounting Screws Placing Heater On Mounting BracketSupply Connecting To GASQualified service person must connect heater to gas supply Follow all local codesConnections Pressure Testing GAS Supply Piping SystemChecking GAS Servicing. Correct all leaks at onceConnecting Pressure Testing Heater GAS ConnectionsOperating Heater Operating Heater Lighting InstructionsHeater To Select Heating LevelShutting Off Heater Shutting Off Burner Only pilot stays litOperating If you do not follow these instructions exactly, a fire orModels VP1600C and VP2600C LOW MED High Inspecting Burner Pilot Flame PatternBurner Flame Pattern Trouble Shooting CleaningMaintenance ODS/PILOT and Burner OrificeCleaning and Mainte TroubleSee Cleaning TROUBLE- ShootingIf you smell gas ServiceTechnical Shut off gas supplyVP1600IT VP2200IT Service Publications HintsVP1600C VP2600C Replacement Parts AccessoriesIllustrated Parts Breakdown Model VP1600ITParts List KEY Part Number Description QTYModel VP2200IT Parts List Model VP1600C Control Position Label Model VP2600C Parts List Warranty Information Keep this Warranty