Chamberlain WD962KD, WD962KLD Light feature, Lock feature, Additional feature when used with

Using the Wall-Mounted Door Control

THE MOTION DETECTING CONTROL CONSOLE

Press the push bar to open or ctose the door. Press again to reverse the door

during the closing cycle or to	Push
	Bullon
stop the door while it'sopening.
This door control contains a
motion detector that will
automatically turn on the light
when it detects a person entering	Dr
the garage.. This feature can be	/
easily turned off for extended
	LOCl
work light use.	Bulton
	Button Ught
Light feature

Press the Light button to turn the opener light on or off.. It will not control the opener lights when the door is in motion.. If you turn it on and then activate the opener, the light will remain on for 4-t/2 minutes_ Press again to turn it off sooner. The 4-1/2 minute interval can be changed to 1-1/2, 2-1/2 or 3-I/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes,. Repeat again for a 3-I/2 minute interval, etc..,up to a maximum of four blinks and 4-1/2 minutes..

When using the opener lights as working lights, we recommend that you first disable the motion sensor See Motion Detecting Light Feature, following.

Motion Detecting Light Feature: The opener light will turn on automatically when a person walks in front of the wai!-mounted control console. This feature works by detecting motion and body heat and may not work in temperatures around 100°F, 37._7C The opener light will come on for 5 minutes, then shut off automatically if no additional motion or heat differential is calculated..

To disable this feature, slide the Detector Switch on the right side of the door control down (off)..

We recommend that you disable the motion sensor when using the opener lights as working lights.. Otherwise, they will turn off automatically if you are working beyond the sensor'srange.,

Lock feature

Designed to prevent operation of the door from hand-held remote controls_ However, the door will open and close from the Door Control, the Outside Keylock and the Keyless Entry Accessories_

To activate, press and hold the Lock button for 2 seconds.. The push bar light will flash as long as the Lock feature is on,,

To turn off, press and hold the Lock button again for

2 seconds,The push bar light will stop flashing The Lock feature will also turn off whenever the "Smart" (learn) button on the motor unit panel is activated..

Additional feature when used with the

3-button hand-heM remote

To control the opener lights:

I..With the door closed, press and hold a small remote button that you want to control the lighL

2_Press and hold the Light button on the control console..

3.While holding the Light button, press and hold the Lock button on the control console..

4.After the opener lights flash, release all buttons.

32