Chamberlain WD962KD, WD962KLD owner manual Adjustment Step, Doora,desiredlll

ADJUSTMENT STEP 1

Program the Travel Limits

Travel limits regulate the points at which the door will

stop when moving up or down. Follow the steps below to set the limits.

To program the travel limits:

Figure 1

° o

tndic_tor Ught

- Black Buttot_

- PurpleBlJtlon

Adjust the position of the door by using the black and purple buttons.. Black moves the door UP (open) and purple moves the door DOWN (close).

Without a properlyinstalledsafetyreversalsystem,persons (particularlysmall children) could be SERIOUSLYINJUREDor KILLEDby a closinggaragedoor.

°Incorrectadjustmentof garagedoor travel limits will interfere with proper operationof safetyreversalsystem,

=NEVERuseforce adjustmentsto compensatefor a bindingor stickinggaragedoor_l

•AfterANYadjustmentsaremade,the safetyreversalsystem MUSTbetested. Door MUSTreverseon contactwith 1-1/2"

(38 cm) high object (or 2x4 laidflat) on floor,.

To preventdamageto vehicles,be sure fully opendoor providesadequateclearance,

1..Setting the UP position: Press and hold the black button until the yellow indicator light starts flashing

slowly then release,,

2oPush and hold the bIack button untit the door reaches the desired UP (open) position (Figure 2)..

Figure 2

Indicator Ught

NOTE: Check to be sure the door opens high enough for your vehicle..

3oPush the remote control or door control (Figure 3). This sets the UP (open) limit and begins closing the door,.

4..Immediately when the door begins to move down, press and release either the black or purple button.. This will

stop the door..

5 Setting the DOWN position: Push and hold the purple button until the door reaches the desired DOWN

(closed) position (Figure 4),

6..Once the door is closed, if there appears to have too much pressure on the door, you may toggle the door back and forth using the black and purple buttons to reach the desired closed position.

7, Push the remote control or the door control (Figure 3)7 This sets the DOWN (close) limit and should bring the door to the open position,,

-If the opener is not stopping exactly where you would like it, repeat steps 1 through 7 and program the limitsagain.

=When the unit stops in both the desired up (open) and down (close) positions, proceed to Adjustment Step 2, Setting the Force..

"until the door

isPushat desiredandholdUP posilion

Figure 3

OR

Figure 4

Indicator Ught

Push either ._ button toslop _,*-_.

doora,desiredll_l

DOWN position [J---_-- U

28