Chamberlain WD962KD, WD962KLD Installing the Brackets, Garage door track installation preferred

INSTALLING THE BRACKETS

Be sure power to the opener is disconnected. Instal] and align the brackets so the sensors will face each other across the garage door, with the beam no higher than 6" (15 cm) above the floor.. They may be installed in one of three ways, as follows..

Garage door track installation (preferred):

oSlip the curved arms over the rounded edge of each door track, with the curved arms facing the door.. Snap into place against the side of the track.. It should lie flush, with the lip hugging the back edge of the track (Figure 1)

If your door track will not support the bracket securely, wall instaIlation is recommended.

Wall installation (Figures 2 and 3):

-Place the bracket against the wall with curved arms

facing the door.. Be sure there is enough clearance for the sensor beam to be unobstructed.

otf additional depth is needed, an extension bracket (see Accessories) or wood blocks can be used

°Use bracket mounting holes as a template to locate and drill (2) 3/16" diameter pilot holes on the wall at each side of the door, no higher than 6" (15 cm) above the floor..

°Attach brackets to watt with lag screws (not provided)..

,if using extension brackets or wood blocks, adjust right and left assemblies to the same distance out from the

mounting surface. Make sure all door hardware obstructions are cleared..

Floor installation (Figure 4):

°Use wood blocks or extension brackets

(see Accessories) to elevate sensor brackets so the lenses will be no higher than 6" (15 cm) above

the floor..

o Carefully measure and place right and left assemblies at the same distance out from the wall Be sure all door hardware obstructions are cleared..

° Fasten to the floor with concrete anchors as shown.

Figure 1 DOORTRACK MOUNT (RIGHT SIDE)

LDoor

rackel

Figure 2 WALL MOUNT (RIGHT SIDE)

Fasten Wood Block to Wall with (Not Provided)

Indicator

Ught Sensor

Figure 3 WALL MOUNT (RIGHT SIDE)

_tt Bracket

i _ : i (See Accessories)

(Providedwilh

II1		_22 "_-		r._enslon Bracket)
(Provide,w'"L___				S_an_k°rt
Extension	=--_,,_" _			\
Bracket)	_	_	!	Indicator
			Lens	Light

Figure 4 FLOORMOUNT(RIGHTSIDE)

HARDWARE SHOWN ACTUAL SIZE	_	tlach with
	;	Concrete Anchors
		(Not Provided)

		Indicator
Carriage Be}It	Wing Nut	Light
		Slaples
t 14"-20xt/2"	t/4"-20
		Bracket

22