Chamberlain WD962KLD, WD962KD To Add or Reprogram a Hand.held Remote Control, Button, 315 MHz

PROGRAMMRNG

NOTICE: if this Security't ,_ garage door opener is operated with a non-rolling code remote control the technical measure in the receiver of the garage door opener, which provides security against code-theft devices, will be

circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the non-rolling code remote control to circumvent that technical measure.,

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control,, The door will open and close when you press the large push button,

Below are instructions for programming your opener to operate with additional Security.I ,° 315 MHz remote controls.

To Add or Reprogram a Hand.held Remote Control

USING THE "LEARN" BUTTON USING THE MOTION DETECTING DOOR CONTROL

1,, Press and release the "learn" button on the motor unit., The learn indicator light will glow steadily for 30 seconds,

2.Within 30 seconds, press and hold the button on the hand-held remote* that

you wish to operate your garage door.,

3.Release the button when the motor unit

lights blink., It has learned the code, If	.. I /
light bulbs are not installed, two clicks
will be heard,,

To

Erase

All

Codes

From Motor

Unit

Memory

To deactivate any unwanted remote, first

erase

all

codes:

.

_.___

I

I

Press

and held the learn"

button

on

motor

I "_

![--It I

t

unit until

the learn

indicator

light goes

out

]

I

_

I

I

(approximately 6 seconds)°

Alt previous

]

I

_::A::qlI

J

codes

are now erased,

Reprogram

each

I

_f(

}_ J

t

remote

or keyless

entry

you wish

to use.

]

k__

1./

I

I. Press and hold the button on the hand-held remote* that you wish to operate your garage door,

2,, White holding the remote button, press and hold the LIGHT button on the

Motion Detecting Door Control,

3, Continue holding both buttons while you press the push bar on the Motion Detecting Door Control (all three buttons are held),

4o Release buttons	when the motor	unit	..,I /
lights blink It has learned the code, If
light bulbs are not installed, two clicks
will be heard..
*3.Button	Remotes	(315	MHz)

If provided with your garage door opener, the large button is factory programmed to operate it.. Additional buttons on

any Security÷ ® 3-button		.t"_/__,._	_
remote or mini-remote can
be programmed	to operate
other Security÷	e garage	,	I
doo

37