Nilfisk-ALTO 05230F, 05220G, 05211F, 05231F, 05221F, 05220F, 05210G, 05210F manual Table of Contents

READ THIS BOOK

This book has important information for the use and safe operation of this machine. Failure to read this book prior to operating or attempting any service or maintenance procedure to your Nilfisk ALTO machine could result in injury to you or to other personnel; damage to the machine or to other property could occur as well. You must have training in the operation of this machine before using it. If your operator(s) cannot read this manual, have it explained fully before attempting to operate this machine.

All directions given in this book are as seen from the operator’s position at the rear of the machine.
Table of Contents
Operator Safety Instructions	3
Introduction	4
Machine Specifications	5
Procedures For Transporting	7
Symbols Used On S & L Models	8
Machine Control Panel S Models	10
Machine Control Panel L Models	12
Display Screen For L Models	14
Machine Controls and Features	15
How To Prepare The Machine For Operation	16
How To Install The Batteries	16
Battery Maintenance	17
How To Charge The Batteries	18
How To Install The Brushes Or Pad Drivers	19
How To Remove The Brushes Or Pad Drivers	19
How To Operate The Machine	20
How To Operate The One Touch System	20
Reprogramming One Touch	20
How To Return One Touch To Factory Default Setting	20
How To Operate The Squeegee	21
How To Fill The Solution Tank	21
How To Traverse Machine	22
How To Clean A Floor	22
Maintenance	23
How To Correct A Problem	28
Common Error Codes (SRUBTEC 770 L, 784 L & 795 L)	29
Accessories	30
Section II Parts and Service Manual
Solution Tank Assembly	32-33
Recovery Tank Assembly	34-35
Electrical Panel Assembly S Models (Solo Controller)	36-37
Electrical Panel Assembly S Models (I-Drive Controller)	38-39
Electrical Panel Assembly L Models	40-41
Control Panel Assembly L Models	42
Control Panel Assembly S Models (Solo Controller)	43
Control Panel Assembly S Models (I-Drive Controller)	44-45
Squeegee Swing Arm Assembly	46-47
Squeegee Assembly 770, 784	48-49
Squeegee Assembly 795	50-51
Traverse System Assembly	52-53
Brush Head Assembly	54-55
Brush Motor	56
Gearbox	57
Imperial Transaxle Parts	58-59
Accessories	60
Electrical Schematic S Models (Solo Controller)	61
Electrical Schematic S Models (I-Drive Controller)	62
Electrical Schematic L Models	63

-2- FORM NO. 70935A Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795