HOW TO OPERATE THE MACHINE
How To Traverse Machine
NOTE: Put the machine in the slow traverse speed (see figure #17). Use the machine in an area that has no furniture and objects until you can do the following:
1.Move the machine in a straight direction, forward and backward.
2.Stop the machine safely.
3.Move the machine in a straight direction after you turn the machine. To move the machine, follow this procedure:
1.Turn the key switch “ON” position.
2.Put the brush switch in the “UP” position.
3.Raise the squeegee.
4.To go forward, push one or both of the yellow forward switches (see figure #18).
5.To stop the machine, release the yellow forward switches.
6.To go backward, push in on the white reverse button and one of the yellow forward switches at the same time (see figure #19).
7.To turn the machine, push the rear of the machine to the side.
8.When you stop the machine, turn the key switch “OFF”.
How to Clean a Floor
WARNING!
Water solutions or cleaning materials used with this type of machine can leave wet areas on the floor surfaces. These areas can cause a dangerous condition for the operator or other persons. Always put CAUTION signs near the area you are cleaning.
To clean a floor, follow this procedure:
1.Put the water and a cleaning chemical in the clean solution tank.
2.Turn the key switch “ON”. If one touch feature is used, press the green button and proceed to step 6 (deluxe models only).
3.Lower the squeegee.
4.Put the brush switch in the “DOWN” position.
5.Adjust the flow of clean solution to the flow desired.
6.Move the machine across the floor in the forward direction.
7.Make a 180 degree turn.
NOTE: When you make more passes across the floor, let the brushes clean approximately 2 inches of the area already cleaned by the brushes.
NOTE: During most cleaning procedures, apply and remove the solution in one operation.
Figure # 17
Figure #18
Figure #19
Page | Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795 |