HOW TO PREPARE THE MACHINE FOR OPERATION
How To Install The Brushes Or Pad Drivers
To install the brushes or pad drivers on the machine, follow this procedure:
1.Turn the key switch “ON”.
2.Put the brush switch in the “UP” position.
3.Turn the key switch “OFF”.
4.Go to the front of the machine.
5.Unlatch right and left brush housings and remove them. See figure #9.
6.Put a brush or pad driver under the brush motor plate. See figure #10.
7.Align the lugs on the motor gimbal with the slots in the brush gimbal.
8.Pull the brush up until the gimbal locks.
9.Repeat steps 6, 7, and 8 to install the second brush or pad driver.
How To Remove The Brushes Or Pad Drivers
To remove the brushes or pad drivers from the machine, follow this procedure:
1.Turn the key switch “ON”.
2.Put the brush switch in the “UP” position.
3.Turn the key switch “OFF”.
4.Go to the front of the machine.
5.Push down on two sides of the brush or pad driver until the gimbals release.
Figure #9
Figure #10
Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795 | FORM NO. 70935A - 19 - |