Toshiba TDP-EX20 owner manual Using the menus, How to set password from Off to On

Using handy features (Continued)

How to set password (from [Off] to [On])

1Select [Password] in the Default setting 2 menu and press the or button.

2Select [Password setting] in the password registration, setting menu, and press the or button.

3Select [On].

4 Select [OK] and press the button.

The password entry screen is displayed.

Using the menus 1

You can call up on-screen menus, and conduct a number of adjustments and settings using the operation buttons p.18 on the control panel (main unit side) and remote control.

N Setup using the Setting display

The menu shown below is for operation instructions purposes and might differ from the actual display.

1.Press the MENU button Display the Setting display menu.

2.Select a Category

5Enter the password using numeric keys of the remote control.

6The password setting will be set as [On].

How to operate when password is [On]

1Turn on the power.

2The lamp lights and the password entry screen appears.

3 Enter the password using numeric keys of the remote control.

If the entered password is correct, the start-up screen appears and the projector

goes into normal operation. If the password is wrong, a message appears to prompt

Select a category by using . There are following 6 categories:

Image adjustment menu p.38

Position adjustment menu p.39

Display setting menu	p.40
Default setting 1 menu	p.43
Default setting 2 menu	p.44
Status display menu	p.45

Displays the current adjustments and settings of selected category.

Item shown with gray cannot be adjusted with the current input source.

you to re-enter the password, and again the password entry screen is displayed. If

you enter a wrong password for more than 5 times, the projector will automatically

3.Adjustments & Settings Press or to open the menu.

power off and enter standby mode.

Note

•When the password setting is [On], the password will be enabled only when the power is turned on for the first time after the main power switch has been on. The password function will not be activated if the power backed on while it is standby mode without turning off the main power switch.

How to set password (from [On] to [Off])

1Select [Password] in the Default setting 2 menu and press the or button.

The password entry screen is displayed.

Item

Adjustment/Setting Value

These marks signify the items can be adjusted/set by using

.

These marks signify the items can be selected from the list by using .

These marks signify that there are options.

Press or

to display a list of options.

These marks signify that there are setting

screens. Press or to display a list of

setting screens.

*When no item is

changed, press .

Operations

3Select [Password setting] in the password registration, setting menu, and press the or button.

After an item is selected, apply it by

pressing .

Toggle items with	.
Select items with	and press	.
Fix selection with	.

4Select [OFF].

5Select [OK] and press the button.

•The figure shows displays given for operation instructions purposes. As the display may differ depending on the item, use the following pages as a reference.

•To return to previous item, press the RETURN button.

•When Network or USB memory input is selected, pressing the MENU button displays the Setting display (2) menu.

4. End Press the MENU button once more.

(The menu will disappear automatically after 30 seconds, if no operation is conducted.)

36 37