Lamp replacement
A lamp is consumable supplies. If used for extended periods, images will appear dark, and the lamp could burn out. This is characteristic of a lamp, and is not malfunction. (The lifetime of the lamp depends on condition of use.) If this happens, replace it with a new one.
WARNING
•If the projector is mounted on the ceiling, it is recommended to use your Toshiba dealership when the lamp has to be exchanged.
Uncovering the lamp while the projector is mounted on a ceiling may lead to a danger of damage from falling pieces of glass if the lamp is broken. Besides, working at high elevations can also be hazardous. Do not attempt to replace the lamp by yourself.
•When replacing, always use lamp “TLPLW15” (sold separately).
CAUTION
4Remove the inner lamp cover.
Loosen the screw to remove the inner lamp cover.
5Pull out the lamp.
Loosen the 3 lamp locking screws, pull up the handle, and press the tab to remove the lamp.
4
Inner lamp cover
5
•If you have been using the projector, the lamp will be very hot, and may cause burn injuries.
Wait for the lamp to cool (for longer than 1 hour) before replacing it.
•If the lamp should break, please handle with care to avoid injury due to broken pieces and contact your dealer for repair service.
Tab
1Unplug power cord.
2Wait until lamp is sufficiently cooled.
Wait for at least 1 hour.
3 Remove the outer lamp cover. | 3 |
Loosen the 2 screws, raise the outer lamp cover | Outer lamp cover |
with your fingers as shown to remove the outer |
|
lamp cover. Use care to avoid any damage to nails |
|
and/or tip of your finger(s). If you have any difficulty |
|
in removal, you can use a screwdriver or any other |
|
smaller tool for your convenience. |
|
6 | Mount the new lamp. |
|
6 |
Align the orientation, press down the new lamp until the bottom is reached, and lock in place using the 3 lamp locking screws.
7Replace the inner lamp cover.
Tighten the screw loosened in step 4 until the inner lamp cover is no longer loose.
8Replace the outer lamp cover.
Align the cover, and press it in, then tighten the screws loosened in step 3 until the outer lamp
cover is no longer loose. (Be sure to replace the outer lamp cover.)
9Reset the lamp time.
See the lamp’s manual for instructions on resetting the lamp time.
Maintenance
86 | 87 |
