HOW TO OPERATE THE MACHINE
How to Operate the One Touch System (“L Class” models only) One touch cleaning is a feature on the new Scrubtec
1.Press and release the green button for all cleaning functions to begin, see figure #11, item A.
2.The squeegee and brush head lower to the floor and the vacuum starts. NOTE: The squeegee switch must be in the center position for the squeegee to operate with the one touch feature, see figure #11, item B.
3.The brushes and solution will begin only when you begin to traverse.
4.The cleaning will be at the factory default settings, however you can reprogram these settings to your specifications. See “Reprogramming One Touch” section below.
5.To end cleaning process, press the green button again and solution will stop; brushes will raise; after a short delay squeegee will raise; and the motor will turn off.
NOTE: It is intended that this be done while traversing. If you stop and do it, some solution can be left on the floor.
Reprogramming One Touch
If you do not want to use the factory default settings, you may reprogram the setting by following the procedures below:
1.Place the machine in the desired scrub condition by using the one touch and individual switches.
2.Press and hold the green one touch button until you see the LCD display flash, then release the button. NOTE: The time required should be approximately 5 seconds.
3.When you activate or deactivate the one touch, it will now be set to your preference for cleaning. These settings will remain until you disconnect power or reprogram them. NOTE: When programming one touch, be sure squeegee is in automatic (middle) position, otherwise you may program squeegee either up or down all the time.
How to Return One Touch to Factory Default Settings To restore the factory settings, follow the procedures below:
1.Press and hold the green one touch button until you see the LCD display flash two times (5 seconds between flashes), see figure 11. NOTE: The time required for this will be approximately 10 seconds.
2.The settings should be returned to 4 bars of solution and 2 bars of brush pressure. NOTE: The squeegee vac switch must be in the middle position for default settings to work.
B A
Figure #11
Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795 |