MAINTENANCE
Adjusting Squeegee Blades
When properly installed the front blade should be approximately
.12 above the rear blade. See figure #29.
WARNING!
Maintenance and repairs must be done by authorized personnel only.
WARNING!
Electrical repairs must be done by authorized personnel only.
Consult your Nilfisk Alto Authorized Service Person to do the service procedures.
Use only genuine Nilfisk Alto parts.
How to Clean the Solution Line
If the solution line becomes clogged, pull the filter assembly out from behind the brush housing (Figure 30). Turn solution vavle off. Remove the filter screen (Figure 31, B) and clean or replace it. Turn solution valve back on (figure 31, A) and push filter assembly back inside frame.
0.12" (3.0 mm)
Figure #29
Figure #30
A
B
Figure #31
Nilfisk ALTO Operator's Manual - SCRUBTEC 770 / 784 / 795 | FORM NO. 70935A - 27 - |