Sun Microsystems 220R service manual 4Section 2.8 How to Avoid Electrostatic Discharge on

4Section 2.8 “How to Avoid Electrostatic Discharge” on page 69

6.8.2What to Do

1.Route the keyswitch and power on-off cables to their positions in the front of the chassis.Attach the keyswitch cable to the keyswitch assembly.

a.Align the post on the keyswitch with the socket in the connector.

b.Gently insert the keyswitch into the connector.

c.Rotate the keyswitch in the connector until the tabs on the keyswitch snap into place.

The long tab on the keyswitch should lock into the corresponding groove on the cable connector when the keyswitch is properly seated in the connector.

2.Position the Power button in the chassis.

3.Replace the 3/16ths-inch nut on the front of the Power button.

Removing and Replacing Miscellaneous Assemblies 177