4.Align the disk drive to its drive bay.

Orient the drive so that the drive handle's hinge is on the left side of the drive bay.

Note - If you are reinstalling a drive that you previously removed, be sure to reinstall the drive in the same bay from which it was removed.

5.Holding the drive by its handle, fit the drive into the guide rails at the left and right of the drive bay.

6.Slide the drive into the bay until it lightly contacts the backplane.

7.Press carefully on the center of the drive and watch as the handle begins to close.

The drive handle begins to close as the drive engages its backplane connector.

Removing and Installing Storage Devices 131

Page 131
Image 131
Sun Microsystems 220R service manual Align the disk drive to its drive bay