2.2How to Power On the System

2.2.1Before You Begin

If a terminal or local console is not already connected to the system, you need to install one before continuing the startup procedure. For information, see:

4Section 2.10 “About Communicating With the Server” on page 73 Section 2.12 “How to Configure a Local Graphics Console” on page 75

Note - Use the Reconfiguration Boot procedure instead of the power-on procedure if you have just installed an internal or external device or any new part that plugs into the main logic board except a CPU or a DIMM. See Section 2.3 “How to Initiate a Reconfiguration Boot” on page 58 for further information.

Preparing to Service the System 55

Page 55
Image 55
Sun Microsystems 220R service manual How to Power On the System, Before You Begin