Main Remote Control Functions
Memory Button: Press this button to enter a radio station into the AVR ’s preset memory. Two underline indicators will flash at the right side of the Main Information Display Ò, you then have five seconds to enter a preset memory location using the Numeric Keys H. (See page 51 for more information).
Delay/Prev Ch.: Press this button to begin the process for setting the delay times used by the AVR when processing surround sound. After pressing this button, the delay times are entered by pressing the Set button F and then using the ⁄/¤ buttons D to change the setting. Press the Set button again to complete the process. (See page 34 for more information).
›Button: Press this button to change a setting or selection when configuring many of the AVR’s settings.
Speaker Select: Press this button to begin the process of configuring the AVR’s Bass Management System for use with the type of speakers used in your system. Once the button has been pressed, use the ⁄/¤ buttons D to select the channel you wish to set up.
Press the Set Button F and then select the speaker type (Large, Small or None) appropriate with the speaker in use. (See page 31 for more information).
Mute: Press this button to momentarily silence the AVR or TV set being controlled, depending on which device has been selected. When the AVR remote is being programmed to operate another device, this button is pressed with the Input Selector button 4 to begin the programming process. (See page 53 for more information on programming the remote).
Volume Up/Down: Press these buttons to raise or lower the system volume.
Digital Media Player (DMP) Selector: When Harman Kardon’s 
(optional) is connected to 
Digital Media Player (DMP) Connector and a
compatible Apple® iPod® is docked in 
, pressing this selector will select the iPod as the audio source input device for the AVR 347. In addition, if a video display is connected to one of the Video Monitor Outputs , the iPod’s messages will appear on screen, and in the Upper and Lower Display Lines Ò. The ⁄/¤/‹ / › Buttons DE , the Set Button F and the Transport Controls P may be used to navigate the iPod and to operate many functions. See page 45, and the manuals for The Bridge and your iPod for more information.
TV/Video Button: This button does not have a direct function on the AVR, but when used with a compatibly programmed VCR, DVD or satellite receiver that has a “TV/Video” func- tion, pressing this button will switch between the output of the player or receiver and the external video input to that player. Consult the Owner’s Manual for your specific player or receiver for the details of how it implements this function.
NOTE: With the press of any remote button the Input Selector button 45 associated with the botton pressed will briefly flash red to confirm the transmission of the command, as long as there is a function for that button with the device selected (see function list on pages
Dim Button: Press this button to activate the Dimmer function, which reduces the bright- ness of the
Learn Button: The remote control is capable of "learning" individual IR codes from the original remote control that came with your TV or other device that is connected to any of the source inputs. (See page 54 for more information).
Light Button: Press this button to illuminate the buttons on the remote control. Press it again to turn the backlight off, or wait for five seconds after the last button press for the light to turn off on its own.
Tone Mode : Pressing this button enables or disables the Balance, Bass and Treble tone controls. When the button is pressed so that the words TONE IN appear in the Main Information Display Ò, the settings of the Bass and Treble controls and of the Balance control will affect the output signals. When the button is pressed so that the words TONE OUT appear in the Main Information Display Ò, the output signal will be "flat", without any balance, bass or treble alteration.