Bradley Smoker MG-2/BIR3 Cleaning and Maintenance Instructions, Terreon and panel maintenance

Page 12

Express® Lavatory System - MG Series with Battery Infrared Control

 

MG-2/BIR3

Installation Instructions

Cleaning and Maintenance Instructions

IMPORTANT: Strong alkaline or acid-based chemicals and cleansers should not be used to clean the MG-2/BIR3 Express®. If these chemicals come in contact with the Terreon® surface, wipe off the surface immediately and flush with soapy water. Avoid unnecessary or prolonged contact with hot pans and objects.

Terreon® and panel maintenance

The bowl, sprayhead and pedestal end caps are made of Terreon®, a solid cast polyester resin material. Terreon® resists chemicals, stains, burns and impact, and is repairable with everyday cleaners or fine-grit abrasives. The panel is made of stainless steel. With regular cleaning, your MG- 2/BIR3 Express® will provide years of dependable service.

Stainless Steel Access Panel cleaning

Stainless steel is extremely durable, and maintenance is simple and inexpensive. Proper care, particularly under corrosive conditions, is essential. Ordinary deposits of dirt and grease are quickly removed with soap and water. Whenever possible, the metal should be thoroughly rinsed and dried after washing. To remove tightly adhering deposits, use stainless steel polishing powder. In all cases, rub in the direction of the stainless steel grain.

IMPORTANT: Never use ordinary steel wool or steel brushes on stainless steel. Always use stainless steel wool or stainless steel brushes.

Avoid prolonged contact with chlorides, bromides, thiocyanates, and iodides on stainless steel equipment, especially if acid conditions exist. Do not permit salty solutions to evaporate and dry on stainless steel. The appearance of rust streaks on stainless steel leads to the belief that the stainless steel is rusting. Look for the source of the rust in some iron or steel particles which may be touching, but not actually a part of the stainless steel structure. NOTE: Strongly acidic or caustic cleaners may attack the steel causing a reddish film to appear. The use of these cleaners should be avoided.

Terreon® Bowl, Sprayhead and Pedestal End Cap cleaning

IMPORTANT: To sustain original finish, additional care is recommended for dark colored solid surfaces to maintain highest quality color. The original luster can be maintained by periodically applying furniture polish, mineral oil or a solid surface cleaner or polish. For more information on restoring dark colors, see Bradley document #1505. Length of time between applications varies with usage.

For regular cleaning, use standard commercial or household products such as Formula 409® or Windex®.

Remove tough stains with Ajax®, Comet® or Soft-Scrub® and a green Scotch-Brite® pad or lightly sand in a circular motion with 240 grit wet/dry sandpaper. The finish can be renewed with a maroon Scotch-Brite® pad.

Remove scratches with a green Scotch-Brite® pad. The finish can be renewed with a maroon Scotch-Brite® pad. Remove hard water build-up with a mild solution of vinegar and water.

*Use of brand names is intended to indicate a type of cleaner and does not constitute an endorsement.

**It is emphasized that all products should be used in strict accordance with package instructions.

Repair kit: A repair kit is available from Bradley to repair/patch the Terreon® bowl and shelf. Contact your Bradley representative to order a repair kit and be sure to specify color.

12

8/23/07

Bradley Corporation • 215-1510 Rev. D; ECN 07-815

Image 12
Contents Installation Instructions Table of ContentsPre-Installation Information MG-2/BIR3 Express Lavatory System Dimensions Dimensions Installation Instructions Rough in supplies and optional hot water heater23/07 Bradley Corporation 215-1510 Rev. D ECN Rough in wall anchors Mount frame to wall Install bowl assembly Do not overtightenHot Connecting electrical and supply tubing Counterclockwise to increaseCleaning and Maintenance Instructions Terreon and panel maintenanceStainless Steel Access Panel cleaning Terreon Bowl, Sprayhead and Pedestal End Cap cleaningAssembly of Components Other replacement partsSensor assembly and solenoid valve access Infrared Window Sprayhead Body NUT Troubleshooting BIR3 Components Solution Remove debris between diaphragm and the valve seatSolenoid Valve S07-072 closed body and S07-072A thru body Thermostatic Mixing Valve Maintenance and Troubleshooting Problem Limited water flowProblem External leaks in the system Vernatherm Thermostatic Mixing Valve S01-524 Repair Kit S65-259